Automatic Flight Flashcards
When does automatic changeover of IAS to Mach occur?
Approx FL260
MCP condition speed symbols, what are they and where do they appear?
Displayed to the left of the Speed in the IAS/Mach window.
Upper-speed limiting (Flashing character A) - Minimum speed
Over-speed limiting (Flashing character 8)
-VMO or MMO limit
-LDG Gear limit
-Flap limit
When does N1 mode automatically engage?
Engaging LVL CHG in a climb (Except during inhibit period for 2 and a half minutes after lift-off) and engaging VNVAV in a climb.
If you push ALT INTV during a VNAV climb, what happens?
- Lowest FMC altitude constraint below selected MCP altitude is deleted
- If currently at a constraint, deletion allows a/c to resume climb (If MCP is set at a higher altitude)
-If MCP altitude is set above current FMC altitude, FMC cruise altitude resets to MCP altitude - FMC cruise altitude cannot be decreased using ALT INTV switch.
Will LNAV engage in flight if selected outside of 3nm?
Yes, if the a/c:
- Be on an intercept of 90 degrees or less
- Intercepts route segment before the active waypoint.
Is auto throttle a function of FCC A or FCC B or both?
FCCA only!
What IRS do FCCA and FCC B get their information from?
FCC’s receive their heading information from the on side IRS and Roll data from the off-side IRS.
What is the latest the 2nd A/P can be selected?
800’ RA
What is the latest FLARE can be armed?
350’ RA
When does A/T disconnect on an auto land?
2 seconds after the touchdown.
CWS mode - pressure is applied but related prior to a bank angle of 6 degrees, what happens?
Autopilot rolls wings level.
In what modes of auto throttle can you move the throttles without them “Fighting” you?
THR HLD and ARM
In TO/GA mode, the AFDS commands pitch attitude in the following order:
10 degrees nose down until 60kts
15 degrees nose up after lift off until a sufficient climb rate is acquired then?
Pitch is commanded to MCP speed (Which should be V2) plus 20kts
TO/GA can be pushed and will engage below what altitude?
2000’ RA
What can cause thrust lever separation with Auto throttle in?
One ECC on “On” and one on ALTN could cause some asymmetry with the thrust levers.