*'95 Simon-LTI Flashcards
95’ Simon LTI- what two degrees will the “Approaching Jackknife” indicator light illuminate?
65 and 90
On the ‘95 Simon-LTI, In the event air brake system pressure drops below approximately ____ psi a warning buzzer and light will come on. As soon as system air pressure increases past ___ to ___ psi, the warning light and buzzer will shut-off.
65psi, 65-75psi
Also states below 60 PSI the “Low Air Pressure” indicator light will illuminate
All rigs- Which axel (front or rear) has the primary air brakes circuit?
Rear
All rigs- the secondary air brakes circuit is found supplying which axel?
Front
On the ‘95 Simon-LTI, what is the maximum air restriction for the “Air Cleaner Gauge” at full load governed rpm?
25 in. H20
On the ‘95 Simon-LTI, what is the maximum air restriction for the “Air Cleaner Gauge” at no-load governed rpm?
12 in. H20
On the ‘95 Simon-LTI CUMMINS, the “Low Engine Oil Pressure” indicator light illuminates when oil pressure drops below what psi?
3 psi
All rigs-The ignition switch is a ____ style switch that when closed, allows current to flow to specific electrical accessories.
Rocker
All rigs- what range of amps will the MDC continue to draw even though the master battery switch is off?
7-8 amps
All rigs- when the “Parking Brake” is set, it releases which axels (front or rear) spring brakes?
Rear
All rigs- the in cab “High Idle” switch raises the engine to what rpm?
1000 rpm
On the ‘95 Simon-LTI CUMMINS, what is the normal operating range for engine rpm?
This also delivers the best fuel economy.
1200-1600
All rigs- under full acceleration the transmission will shift automatically at what rpm?
Only difference is the ‘93 Simon. What rpm will this rig shift at?
2100 rpm
1900-2000 rpm
For the Allison Automatic Transmission, Which gear range should be selected when pulling through mud or whenever maximum traction is desired, when maneuvering in tight spaces, or while driving up or down steep grades?
Gear 1
All rigs except ‘93 Simon- Do not crank the engine for more than ___ seconds at a time and hesitate ___ seconds before making another attempt.
-After How many starting attempts should an inspection be made to determine the cause?
What is the interval for the ‘93 Simon?
15 sec and 15 sec
‘93 Simon which states 30 sec and 30 sec
After 4 attempts
When starting an apparatus, If there is no oil pressure indicated within ___ to ___ seconds, stop the engine and check the lubricating system.
10-15
All Rigs- How long should you idle the engine before turning it off in order to let the turbo cool?
4-5 min
- ‘93 Simon LTI logbook recommends 3-5 min
All Rigs- After how many minutes of idling should you turn on the high idle?
After 5