Uniforms Flashcards
WHAT IS THE MAXIMUM SIZE LETTERS ALLOWABLE IN A NAME STAMP FOR MARKING UNIFORMS?
BLOCK LETTERS NOT MORE THAN ONE-HALF INCH IN SIZE.
WHAT MUST YOU DO IF YOU OBTAIN A UNIFORM ARTICLE THAT WAS PREVIOUSLY OWNED BY ANOTHER MARINE?
BLOCK OUT THE OLD OWNER’S NAME AND REMARK THE ARTICLE WITH YOUR OWN. AN APPROPRIATE ENTRY MUST BY MADE IN YOUR RECORD BOOK SHOWING THAT YOU POSSESS AN ARTICLE OF CLOTHING THAT HAS BEEN REMARKED.
WHERE AND HOW SHOULD ORGANIZATIONAL CLOTHING BE MARKED?
ALL ITEMS OF ORGANIZATIONAL CLOTHING MUST HAVE NAME TAGS SEWN IN GARMETS.
WHERE SHOULD YOU MARK CAP COVERS?
INSIDE THE BAND.
WHERE SHOULD YOU MARK THE HANDBAG? (WOMAN MARINES)
ON THE SPACE PROVIDED.
WHERE SHOULD YOU MARK THE PLASTIC HAVELOCK?
ON THE UNDERSIDE OF THE SWEATBAND.
WHERE SHOULD YOU MARK NECKTIES?
ON THE INSIDE OF THE NECKLOOP.
WHERE SHOULD YOU MARK THE NECKTABS? (WOMAN MARINES)
ON THE UNDERSIDE, NEAR THE LEFT END.
WHERE SHOULD YOU MARK TROUSERS/SKIRTS/SLACKS?
INSIDE THE WAISTBAND.
WHERE SHOULD YOU MARK SHOES AND BOOTS?
INSIDE NEAR THE TOP.
WHERE SHOULD YOU MARK THE SCARF?
PARALLEL TO THE WIDTH, NEAR ONE END.
WHERE SHOULD YOU MARK SWEATERS?
ON THE LABEL, OR NAMETAPE SEWN WITH OLIVE GREEN THREAD, INSIDE BACK BELOW NECKBAND.
WHERE SHOULD YOU MARK UNDERSHIRTS?
INSIDE THE BACK NEAR THE NECKBAND.
WHERE SHOULD YOU MARK THE ALL-WEATHER COAT LINER?
CENTERED NEAR THE TOP.
WHEN DOES A MARINE RECEIVE HIS FIRST PAYMENT OF CLOTHING ALLOWANCE?
AFTER SIX MONTHS IN THE MARINE CORPS, YOU WILL ACCURE A CLOTHING REPLACEMENT ALLOWANCE WHICH IS PAID ANNUALLY.
WHAT IS THE PURPOSE OF THE CLOTHING ALLOWANCE PAID TO YOU?
IT IS TO BE USED TO REPLACE UNSERVICABLE UNIFORM CLOTHING AND TO PURCHASE NEWLY ADOPTED UNIFORM CLOTHING.
HOW SHOULD GOLD UNIFORM BUTTONS BE CLEANED.
WITH A WEAK SOLUTION OF HOUSEHOLD AMMONIA AND WATER.
HOW SHOULD SERVICE INSIGNIAS BE REFINISHED IF THEY LOOSE THEIR COATING?
THE INSIGNIA WILL EITHER BE REPLACED OR REFINISHED WITH USMC APPROVED LIQUID, BLACK PROTECTIVE COATING AS SOLD THROUGH MARINE EXCHANGES. (THE USE OF PAINTS OR OTHER COLORING AGENTS ARE PROHIBITED).
HOW MANY TIMES SHOULD THE TROUSER WEB BELT BE WASHED PRIOR TO CUTTING TO FIT?
BELTS SHOULD BE WASHED AT LEAST THREE TIMES BEFORE CUTTING TO NORMAL WAIST SIZE.
WHAT PREVENTIVE MEASURES CAN YOU TAKE TO PROTECT UNIFORMS FROM MOTH DAMAGE?
FREQUENT BRUSHING AND EXPOSURE TO SUNSHINE AND FRESH AIR WILL WILL PREVENT MOTHS.
WHAT WILL ADVERSELY AFFECT THE WEAR-LIFE OF THE UTILITY UNIFORM?
STARCHING, “SIZING”, OR OTHERWISE ARTIFICIALLY STIFFENING.
HOW SHOULD THE ALL-WEATHER COAT BE CLEANED?
DRY CLEANED ONLY.
WHAT SHOULD BE DONE TO THE ALL-WEATHER COAT AFTER FOUR OR FIVE CLEANINGS?
A WATER REPELLENCY TREATMENT SHOULD BE APPLIED.
IF IN DOUBT ABOUT WHAT CLEANER OR POLISH TO USE ON SYNTHETIC LEATHER SHOES, WHAT SHOULD YOU DO?
TRY A LITTLE ON THE INSTEP NEAR THE SOLE TO SEE WHAT AFFECTS IT GIVES.
WHAT SHOULD BE USED TO ABSORB MOISTURE INSIDE LEATHER FOOTWEAR?
FOOT POWDER SPRINKLED LIBERALLY.
WHAT SHOULD THE LENGHT OF THE LONG-SLEEVE SHIRT BE?
IT SHOULD COVER THE WRIST BONE AND EXTEND TO A POINT 2 INCHES ABOVE THE SECOND JOINT FROM THE END OF THE THUMB. A TOLERANCE OF 1/2 INCH, PLUS OR MINUS IS ACCEPTABLE.
WHAT DO THE SEVEN TROUSER BELT LOOPS ON A MARINES UNIFORM REPRESENT?
THE SEVEN SEAS
WHAT DOES THE BLOOD STRIPE ON THE MARINE DRESS BLUE REPRESENT?
THE BATTLE OF CHAPULTEPEC, MEXICO.
WHAT SHOULD THE LENGTH OF THE TROUSER LEGS BE?
THE TROUSERS WILL BE LONG INOUGH TO BREAK SLIGHTLY OVER THE SHOE IN THE FRONT AND TO REACH THE JUNCTION OF THE WELT OF THE SHOE IN THE REAR. A VARIATION OF 1/4 INCH ABOVE OR BELOW THE TOP OF THE HEELIS ACCEPTABLE.
HOW MUCH HEM SHOULD THERE BE ON THE TROUSER LEGS?
HEM FROM 2 TO 3 INCHES.
HOW SHOULD TROUSERS FIT?
TROUSERS SHALL BE OF SUFFICENT LOOSENESS AROUND THE HIPS AND BUTTOCKS TO PREVENT GAPPING OF THE POCKETS AND VISIBLE HORIZONTAL WRINKLES ACROSS THE FLY FRONT OR COAT FLAP. THE FLY OF THE TROUSERS SHALL HANG IN A VERTICAL LINE WITHOUT GAPPING WHEN UNZIPPED. THE PROPER POSITION FOR FITTING OF ALL TROUSERS IS BY PLACING THE BOTTOM OF THE WAISTBAND ATOP THE HIPBONE, PLUS OR MINUS 1/2 INCH IN THE DIRECTION THE INDIVIDUAL WOULD NORMALLY WEAR HIS TROUSERS.
WHAT SHOULD THE PROPER LENGTH OF THE TROUSER WEB BELT BE?
2 TO 4 INCHES BEYOND THE BUCKLE.
HOW MUCH OVERLAP SHOULD THERE BE TO THE FRONT FLAP OF THE GREEN SERVICE COAT?
3 TO 4 INCH OVERLAP.
: WHAT SHOULD THE LENGTH OF THE SLEEVE ON THE GREEN SERVICE COAT BE?
EXTEND TO A POINT 1 INCH ABOVE THE SECOND JOINT FROM THE END OF THE END OF THE THUMB, OR MINUS 1 INCH AND COVER THE SHIRT CUFF.
WHAT SHOULD THE LENGTH OF THE GREEN SERVICE COAT BELT BE?
2 3/4 INCHES TO 3 3/4 INCHES BEYOND THE BUCKLE.
HOW SHOULD THE GARRISON CAP BE WORN?
CENTERED SQUARELY, OR SLIGHTLY TILTED TO THE RIGHT, WITH THE TOP UNBROKEN, AND THE BASE OF THE SWEATBAND ABOUT 1 INCH ABOVE THE EYEBROWS.
HOW SHOULD THE SERVICE/DRESS CAP BE WORN?
FIT SNUGLY AND COMFORTABLY AROUND THE LARGEST PART OF THE HEAD. THE LOWER BAND OF THE FRAME WILL REST HIGH ENOUGH ON THE HEAD TO PRECLUDE THE TOP OF THE HEAD FORCING THE COVER ABOVE ITS NATURAL TAUNTNESS. THE SERVICE/DRESS CAPS ARE WORN CENTERED AND STRAIGHT WITH THE TIP OF THE VISOR IN LINE WITH THE EYEBROWS.
HOW IS THE USMC DECAL PLACED ON THE UTILITY UNIFORM WITHOUT SPLIT POCKET?
PLACED ON THE LEFT BREAST POCKET, USMC INITIALS CENTERED HORIZONTALLY, 1 INCH ABOVE THE BOTTOM EDGE OF THE POCKET.
HOW SHOULD YOU PLACE THE SERVICE STRIPES ON THE GREEN SERVICE COAT?
CENTERED ON THE SLEEVES 1/2 INCH ABOVE THE POINT OF THE CUFF AT A 30 DEGREE ANGLE.
HOW SHOULD YOU PLACE THE SERVICE STRIPES ON THE DRESS BLUE COAT?
CENTERED ON THE SLEEVE WITH THE LOWER EDGE OF THE STRIPE TOUCHING THE FORWARD EDGE PIPPING OF THE CUFF AT A 30 DEGREE ANGLE.
HOW SHOULD YOU WEAR THE COLLAR EMBLEMS ON THE GREEN SERVICE COAT?
CENTERED ON THE COLLAR, ANCHORS FACING INBOARD, WING PARALLEL WITH THE DECK.
WHAT UNIFORM ITEMS ARE ALLOWED TO BE WORN WITH CIVILIAN CLOTHES?
CUFF LINKS, STUDSM TIE BAR, MOURNING BAND, FOOTWEAR, GLOVES, SOCKS, DRAWERS, WHITE UNDERSHIRTS, BLACK BOW TIE, GREEN SERVICE SWEATER,GREEN WOOL SCARF, AND THE ALL-WEATHER COAT WITHOUT INSIGNIA OF GRADE.
(ITEMS THAT HAVE BEEN DECLARED OBSOLETE MAY BE WORN PROVIDED SUCH ITEMS CONTAIN NO DISTINCTIVE INSIGNIA OR BUTTONS).
WHO DESIGNED THE CAMOUFLAGE PRINT FOR THE UTILITY UNIFORM?
NORVELL GILLESPIE.
WHAT SHOULD THE LENGTH OF THE ALL-WEATHER COAT BE?
TO A TARGET LENGHT MIDWAY BETWEEN THE KNEE AND THE MIDCALF.
HOW LONG SHOULD THE ALL-WEATHER COAT BELT BE?
ONE INCH BEYOND THE BELT KEEPER TO 1 1/2 INCHES BEYOND THE LEFT BELT LOOP ON THE COAT.
WHAT SHOULD THE LENGHT OF THE GREEN SERVICE COAT BE?
TO EXTEND ABOUT 1 TO 2 INCHES BELOW THE INDIVIDUALS CROTCH.