Unifire Chainsaw

Question 1

Disengage the chain brake by pulling the hand gaurd

Answer 1

Towards the front handle

Question 2

For warm engine starting, use the same procedure as for cold engine but without

Answer 2

Choke

Question 3

To start, grip the front handle with your left hand and hold the saw down by putting your

foot in the rear handle

Answer 3

Right

Question 4

The lowest recommended octane rating is

Answer 4

87

Question 5

The fuel mixing ratio is

Answer 5

1:50

Question 6

It is important that the chain oil is the right viscosity according to

Answer 6

Air temperature

Question 7

How often should the fuel filter be changed

Answer 7

At least once a year

Question 8

The chain is correctly tensioned when there is no slack on the underside of the bar, but

Answer 8

It can still be turned easily by hand

Question 9

Clean the air filter

Or more often if the air is exceptionally dusty in the working area.

Answer 9

Daily

Question 10

Clean the filter by brushing or shaking it. A more thorough cleaning of the filter is obtained by

Answer 10

Washing it with soap and water.

Question 11

If the engine is low on power, difficult to start or runs poorly at idling speed, always

Answer 11

Check the spark plug first.

Question 12

The correct spark plug gap is 0.5 mm. The spark plug should be replaced after

Answer 12

About a month in operation or earlier if the electrodes are badly eroded

Question 13

The engine has been broken in after

Answer 13

8-10 tanks of fuel

Question 14

A leaner fuel mixture gives a

Answer 14

Higher engine speed

Question 15

The T screw regulates the

Answer 15

Idling speed

Question 16

If the T screw is turned clockwise this gives a

Answer 16

Higher idling speed

Question 17

The high speed needle H is correctly set when the saw

Answer 17

“4 cycles” a little.

Question 18

The bar should be turned

For more even wear.

Answer 18

Daily

Question 19

Position the saw at a —— degree angle. This angle is preset on your depth gauge?

Answer 19

30

Question 20

Once the cut has been started move saw to a —— degree angle to achieve a precise cut at desired depth.

Answer 20

90

Question 21

Always maintain the angle which is determined by the

Answer 21

Surface angle.