Edraulic Spreader

Question 1

Hurst edraulic devices ARE NOT

Answer 1

Water proof or resistant.

Question 2

Hurst edraulic devices are NOT

Answer 2

Explosion protected.

Question 3

The rescue equipment should not come into contact with

Answer 3

Acids or alkalines. If unavoidable, clean with suitable agent.

Question 4

You can extend the operating time if your edraulic device by

Answer 4

Using several batteries.

Question 5

To open the device, turn the star grip in a ———— direction.

Answer 5

Clockwise

Question 6

Following release, the star grip automatically returns to the central position, fully guaranteeing load retention.

Answer 6

Dead man’s function

Question 7

The rechargeable battery will switch itself off after approximately

Answer 7

10-60 minutes.

Question 8

The following are to be worn when working with the rescue equipment:

Answer 8

Protective clothing
Helmet with visor or goggles
Gloves
Ear protection if necessary

Question 9

The highest force develops in the ————- of the plug- on tip.

Answer 9

Rear area

Question 10

Squeezing is allowed in the area of the tips and

Answer 10

With the special squeezing plates in the arms.

Question 11

It is possible to peel sheet steel with the optional peeling tips of the spreader. The spreader tip must be replaced with

Answer 11

The peeling tip.

Question 12

Every —— or when there might be doubts regarding the safety or reliability of the the unit, an additional function test is to be carried out.

Answer 12

3 years

Question 13

Under normal working conditions routine oil changes are not necessary. After ———— an oil change is recommended.

Answer 13

10 years service life

Question 14

The air suction filter is to be checked at least

Answer 14

Once a year.

Question 15

The LEDs attached on the —- light up the work area.

Answer 15

Operating side

Question 16

Spreading:
Use the —- to increase an existing gap.

Answer 16

Front of the tips only

Question 17

Pulling:
—- must be used for pulling.
Must be checked by an expert at least once a year.

Answer 17

Hurst chain sets

Question 18

Never store with —-

Answer 18

Fully closed arms.

Question 19

The lock of the spreader plug on tips should be —- from time to time.

Answer 19

Greased

Question 20

A visual inspection must be carried out every—-

Answer 20

6 months.

Question 21

This inspection must be performed by a person with the necessary expertise. Must possess adequate specialist knowledge in the fields of electrical engineering and hydraulics.

Answer 21

Annual inspection

Question 22

The air suction filter is to be checked at least —-

Answer 22

Once a year or after use in a dusty environment. If filter is dirt, replace