System Limits Flashcards
What are the limits pertaining to the ADCs prior to takeoff (2)?
- Both ADCs must be in Normal mode
2. The ADC check must have been completed
AHRS 1 & 2 must be in ( ) prior to takeoff.
Normal mode
Do not intentionally ( ) the autopilot.
over power
Autopilot minimum heights
200’ on approach
400’ or MDA (whichever is higher) on non precision approaches
500’ enroute
Delta P limits are
9.9 to -0.5 psi
High-Flow must be off for (3)
- Takeoff and landing
- Anti-ice operations
- above 30,000’
ENG SYNC must be off for (2)
- Takeoff and landing
2. Single engine operations
Max amperage for a GPU must be limited to ( ).
1500 amps
Continuous generator output is limited to ( ), however higher transient loads are authorized for ( ).
300 amps
Engine cross starts and battery charging
Crew and passenger O2 masks are not approved for use above ( ).
40,000’ cabin altitude
Prolonged use of passenger masks above ( ) is not recommended.
25,000’ cabin altitude
Do not extend ( ) with flaps extended while airborne, except ( ).
spoilers
as specified in the Emergency or Abnormal procedures
Auto-spoilers must be armed for takeoff and landing, except ( ) or ( ).
simulated engine failures above V1
touch and go’s
Required cooling periods between consecutive starts
1st attempt, wait 1 minute
2nd attempt, wait 2 minutes
3rd attempt, wait 30 minutes
Operation of TRs is limited to ground operations on ( ).
paved surfaces
TR circuit breakers ( ).
Must not be intentionally pulled while in flight, except as specified in the Emergency or Abnormal procedures.
Can you use TRs in manual mode?
Yes, but they are limited to idle thrust.
Tire limiting speed
165 kts
