Siemens Traction Flashcards
Siemens 3 car train arrangement?
DMA-T-DMB
Driving Motor A -Trailer- Driving Motor B
How many doors on a Siemens?
4
Two per side
What is the difference between DMA and DMB?
DMA- Has the PA circuit Breaker
DMB- Has the CCTV recorder circuit Breaker
What key is used to drive the Siemens train?
Master D Key
Also unkocks the cab doors and bulkhead doors.
The roof mounted equipment of a motor consists of?
P- Pantograph
A- Antenna
S- Surge Arrester
H- HVAC x2
P.A.S.H
Towing Unit Operation: How does it function?
The towing unit reads and writes to and from the brake pipe during a Non-Electrical train rescue.
How do you resret the trip ina Siemens?
The trip can only be reset by:
* The train being at 0km/h
* Turning the Reset switch to the right against the spring and releasing it.
* Return the Master Controller Handle to 0 (coast)
Roof mounted equipment of a Siemens Trailer?
HVAC x 2
How is the siemens trip lowered?
electric motor
The Static Inverter recieves 1500vDC and conerts it to?
400vAC (3 phase)
and
230vAC (single phase)
Master Selector Switch positions?
- Reverse
- Neutral
- Forward
- Set Speed
Overspeed systemn- Forward
Forward maximum speed?
What speed in Forward will the Overspeed system apply the Emergency Brakes when exceeded?
115km
125km/h
Set-speed will limit the train speed to ?, and the overspeed will activate at ?
Limit the train to 6km
Overspeed activates at 8km
Master Controller Handle operating zones?
- Emergency Brake (B7)
- Brake (B1-B6)
- ‘0’
- Drive (D1-D7)
Holding Brake automatically applies when train speed falls below ?
0.2km
Brake Cylinder Pressures
Holding Brake Cylinder Pressure?
110kpa
Brake Cylinder Pressure
B1?
57kpa
up in increments of 26 or 27 kpa
Brake Cylinder Pressures
B3
109kpa
Brake Cylinder Pressures
B6
189kpa
up in increments of 26 or 27 kpa
Brake Cylinder Pressures
Emergency Brake Cylinder Pressure?
280kpa
up in increments of 26 or 27 kpa
If a deadmans switch is not set while the train is above 0.2km, a tone will sound for how long before the emergency brakes are automatically applied?
3sec
The Vigilance Acknowledgement Button sequence before EMY Brake applied?
Flash for 5 secs
Buzz for a further 5 secs
The Duplex Gauge (Pressure Gauge) displays what?
- Main Res Pressure (RED)
- Brake CYLINDER Pressure (WHITE)
The uncouple button on the dash has 2 functions, they are?
- When Illuminated RED, identifyingh that it is coupled
- When flashing RED, indicated Low Main Res pressure