QRH Memory Items Flashcards
Aborted Engine Start
Affected engine start lever CUTOFF
Airspeed Unreliable
Disengage AP and A/T
F/D switches OFF
Flaps extended pitch/power: 10’ & 80% N1
Flaps up pitch/power: 4’ & 75% N1
APU Fire
APU fire switch, pull and rotate, hold for 1 second.
APU switch OFF
Cabin Altitude Warning
Oxygen Mask on set to 100%
Establish crew comms
Pressurisation mode to MAN
Outflow Valve CLOSE
Pax signs ON
Pax Oxygen switch ON
Emergency Descent
CAPTAIN
‘Emergency Descent’
‘Cabin crew descent x2’
FO
Advice ATC and get QNH
Pax signs ON
Descend to 10000 or MSA whichever is higher.
Engine start switch CONT
Thrust levers MINIMUM
Speed brake FLIGHT IDENT
Set speed to MMO/VMO
Engine Fire
A/T DISENGAGE
Thrust lever affected engine CONFIRM & CLOSE
Engine start lever CONFIRM & CUT OFF
Engine fire switch CONFIRM & PULL
*if engine fire switch or ENG OVHT light illuminated, rotate to the stop and hold for 1 second.
Engine Surge or Stall
A/T DISENGAGE
Thrust lever affected engine CONFIRM & RETARD until indications are in limits.
Engine Overheat
A/T DISENGAGE
Thrust lever affected engine CONFIRM & CLOSE
*If ENG OVHT light still on proceed with fire QRH actions.
Severe Engine Damage or Separation
A/T DISENGAGE
Thrust lever affected engine CONFIRM & CLOSE
Engine start lever CONFIRM & CUT OFF
Engine fire switch CONFIRM & PULL
*if engine fire switch or ENG OVHT light illuminated, rotate to the stop and hold for 1 second.
Evacuation
C: Set Parking Brake
C: Speed brake lever DOWN
F: Flaps set to 40
F: Pressurisation mode selector MAN
F: Outflow valve OPEN
C: Engine start lever CUTOFF
C: Advise Cc to evacuate
F: Advise ATC
F: Engine and APU Fire switches PULL (Rotate and Hold for 1 second if fire warning illuminates)
Landing Configuration
Assure correct aeroplane landing configuration.
Loss of Thrust
Engine Start Switches FLT
Engine Start Levers CUT OFF
*when EGT decreases, Engine Start Levers IDLE
**if EGT reaches red line or there’s no increase in EGT within 30 seconds, Engine Start Levers CONFIRM & CUT OFF then IDLE
Rapid Decompression
Oxygen Mask on set to 100%
Establish crew comms
Pressurisation mode to MAN
Outflow Valve CLOSE
Pax signs ON
Pax Oxygen switch ON
Runaway Stabilizer
Control Column HOLD
AP & A/T DISENGAGE
Control the aeroplane Pitch and Speed
TRIM to reduce forces on control column
*if runaway continues both STAB TRIM cut out switched CUT OUT
Take Off Configuration
Assure correct config for take off.