Power Sources Flashcards
Annunciator lights (except for. ) and Master Reset Button
MEDC
SHP
TIT
RPM
FF guages
MEAC
SEAC
Tach Gen
BUS A
Turbine inlet overtemp test switch
Cal A / B Switch
Duct loop test switch
SEAC (just below the SEAC TIT guages)
MEAC (toggle switch = AC)
EMDC (anything duct = EMDC)
Baro Alt Mode C and HSI Mode Lights
MEAC
Turn Needle
MEDC
backup = FEDC with ESS BUS MON switch OFF
Marker Beacon Lights
And baro alt. Vibrator
MEDC
OAT Guage
EMDC (because its outside the plane)
Stby Attitude Indicator (Peanut Gyro)
FEAC
backup = FEDC with ESS BUS MON switch OFF
RADALT
FEAC
Landing gear handle lights and position indicator
EMDC
Flap Position Indicator
Inst Bus 1
EFDI
MEAC backed up by FEAC
AOA Index lights and annunciator
MEDC
Pedestal
overhead lights
Overhead instrument lights
MEAC
Step lights
Circuit breaker lights and FE’s Reading light
BUS A
28v FLB
AP (primary / control)
BUS A / MDC
Rack C-1/2
Command Bell
FEDC
Landing lighted and windshield wipers
MEAC
Taxi, wheel well, wing and tail lights (Nav lights)
28v FLB
Strobe
B: Bus B (primary)
E: EMDC (control)
APU Control Switch & Inflight arming switch
GOB
- APU Exhaust Gas Indicator
- RPM APU Indicator
- Lights Test Switch
- Thermocoulpe
- APU Tach Gen
- APU Ess DC
Pilot / CP lighting control panels
Reference the cross picture (YouTube video)
Fuel dump Pump
Valve?
BUS A / MDC
MDC
Pitot heat switch (pilot and cp) (and heaters)
FEAC (pilot)
MEAC via 28v FLB (cp)
Empennage de-ice. Control switch and wing de-ice mod valve control switches
EMDC
Emp de-ice fault guage
BUS A and BUS B
Propeller De-ice guage
Bus B
Leading edge temp guage and ice detector heater
MEAC
Side windshield heat control switches (primary / control)
Front windshield heat power
BUS A
EMDC
MEAC
(Control relay power = MEDC)
AOA Heat Power
MEDC
Empennage Deice, side windshield heat and prop deice control relays
EMDC
Wing deice mod valves
EMDC
Emp cycling strips and parting strips
BUS B
BUS A
Prop Deice Heating Power
BUS B
Emp Deice Timer Motor
Engine anti ice valve solenoids
MEAC
MEDC
Engine oil system instrument panel
EIEII, 1221
(EMDC, Inst Bus #1 or #2)
Oil quantity guages control power = GOB
Ground AC switch (primary / control)
SEDC / MEDC
Temperature selector, controller and indicator
MEAC
Pressurization ground check switch
MEAC & FEAC
Outflow valve
FEAC
Heat exchanger fans (primary / control)
blows me
BUS B / MEDC
EDC Dump & Disconnect Solenoids
MEDC