Non-Normal Maneuvers Flashcards
Approach to Stall or Stall Recovery? (In cruise, clean config & landing config)
Actions when in cruise in clean configuration
* “Stall”
* “Disengage”
* “Push”
* 5° nose down & maintain until bug speed
* “Roll”
* “Thrust”
* “Stabilise”
* Once at bug speed
* “Select FL___”
* “A/T arm switch on”
* “Select FLCH”
* “Autopilot”
PM
* “PAN PAN PAN Cathay ____, jet upset”
Actions when in landing configuration
* “Stall”
* “Disengage”
* “Push”
* Horizon & maintain until VREF
* “Roll”
* “Thrust”
* “Stabilise”
*NOTE: Do not change gear or flap configuration during recovery
* Once at VREF
* Pitch up to stabilise
* Perform a normal go-around
* “Autopilot”
PM
* “Cathay ____, going around”
Ground Proximity Warning System (GPWS) Response? GPWS Caution & GPWS Warning?
- GPWS Caution
- Correct the flight path or airplane configuration
- GPWS Warning (“PULL UP”, “ OBSTACLE OBSTACLE PULL UP”, TERRAIN TERRAIN, PULL UP”)
- GPWS escape manoeuver
- Disengage AP
- Disconnect Autothrottles
- Max thrust
- Wings level, 20° nose up
- Retract speedbrakes
- Continue to PLI’s if need be
- Do not change gear or flap config until terrain separation is assured
- i.e MSA or visual (from Ops A. If any doubt exists, immediately climb to a known safe altitude)
- GPWS escape manoeuver
- “Cathay ___ TERRAIN WARNING CLIMB”
Rejected Takeoff?
Actions
* “STOP”
- Close thrust levers
- Disconnect A/T
- Apply rev thrust (ensure speedbrakes extend)
- Apply max braking (or check AB working)
- “SPEEDBRAKES UP”
- “REV GREEN” or “NO REVERSER LEFT ENGINE” or “NO REVERSERS”
- “60 kts”
- “PARKING BRAKE SET”
- “Attention Crew at Stations” x 2 or normal PA if RTO poses no threat
- Normal PA, include if there will be emergency vehicles next to the aircraft.
- “Confirm the failure” -> NNC
- (Eng rundown, secure the engine on the RW then taxi off)
- Considerations after an RTO & completing the NNC
- Reverse thrust maintenance action
- Temperatures & TIME (Start the clock. Max temp roughly 15 mins after brake application)
- FlOw - after landing if returning or flow to catch anything out of place (like autobrakes) if taking off again
Traffic Avoidance? (TA, RA & RA in landing config)
- For TA
- Look for traffic on ND & outside
- Call out any conflicting traffic
- If traffic signed, manoeuvre if needed
- Manoeuvres based solely on TAs are not recommended
- For RA (except in landing config)
- If manoeuvring is required
- Disengage A/P
- Disconnect A/T
- Smoothly follow pitch commandsto satisfy RA command
- Follow lateral flight path
- PM”Cathay ___ TCAS RA”
- After clear, transmit “Clear of Conflict” immediately and ask which flight level to return to. May not be the same as previous
- If manoeuvring is required
- For RA (in landing config)
- Disengage A/P
- Disconnect A/T
- Set maximum thrust
- “FLAPS 20”
- Smoothly adjust pitch to satisfy RA command
- Follow lateral flight path
- Verify positive rate of climb & PM call “POSITIVE RATE”
- PF “GEAR UP”
- PM”Cathay ___ TCAS RA”
Upset Recovery
- “Attitude/Stall”
- “Disengage”
- Both A/P & A/T
- “Push”
- “Roll”
- “Thrust”
- “Stabilise”
- NOTE
- PM should call out attitude, airspeed & altitude throughout the recovery
- NOTE
Windshear (Caution & 3 Warnings)
- “MONITOR RADAR DISPLAY”
- Maneuver as required to avoid the windshear
- Normal go around if on approach
- “WINDSHEAR AHEAD, WINDSHEAR AHEAD”
- Prior to V1, reject the takeoff
- After V1, rotate at VR (or 2000’ of runway remaining) & perform the windshear escape manoeuver. Ensure maximum thrust is set as soon as you recognise this, even on the runway
- NOTE: inhibited above 100 kts
- “GO-AROUND, WINDSHEAR AHEAD”
- Windshear escape manoeuver or a normal go-around
- “WINDSHEAR, WINDSHEAR, WINDSHEAR”
- Windshear escape manoeuvre
- Windshear escape manoeuvre
- TO/GA
- Retract speedbrakes
- Do not change configuration
- PM
- Call out any trend toward terrain contact, descending flight path, or significant airspeed changes
- PM