MQF: Flight Operations

Question 1

Each flight crewmember is required to use and refer directly to the appropriate checklist for all phases of operation in which whey participate except during_________

Answer 1

Visual inspection, stating engines, taxi, and takeoff. Touch and go landings, and Emergencies or when specifically allowed by the amplified portion of the of the checklist.

Question 2

Should any crewmember note note a condition which would necessitate discontinuing an engine start, they shall call out, _________ and state reason.

Answer 2

Stop start

Question 3

The Aerial Gunner will state, _______ if the propeller fails to rotate within approximately 5 seconds after pilot states “turning”, for each engine.

Answer 3

Negative rotation

Question 4

Prior to turning GPC switches on confirm that the _______ on the flight deck is ON. If the TGM Power is not ON this step will be delayed until it is.

Answer 4

TGM power switch

Question 5

The following items are required to be accomplished on the GWS Laptop to ensure the 30mm gun will cycle during the trainable weapon check:

Answer 5

Round count entered or zero-round count inhibit disabled, and Nav fault override selected.

Question 6

Prior to enabling TGM motion during the trainable weapon check ensure the GWS laptop is in Ground Safe Mode and the azimuth and elevation read approximately _______.

Answer 6

0 degrees and -10 degrees

Question 7

During take-off and landing operations the M2 sensor will be ________ to avoid damage to the sensor glass. The M1 sensor should be set ________ for takeoffs and jut prior to landing to avoid large un-commanded movements.

Answer 7

Stowed; Forward and stowed

Question 8

Do not install the dunnage corral until the Prestrike Checklist

Answer 8

False

Question 9

Failure to _______ on the GWS laptop may result in lage accuracy discrepancies between the sensor aim point and the gun aim point.

Answer 9

Deselect Nav Fault override

Question 10

Prestrike: If cleared by the PIC to rig for pressure do not complete which steps of the prestrike.

Answer 10

Remove tie-rod and azimuth pin, place manual safe handle to “fire”, and Place TGM motion Switch to ( Enable)

Question 11

During 30mm AHS IN-flight reload, notify crew when ready to take the gun off-line and forward ammunition into the gun. Aerial gunner should wait until the crew is not ___________ prior to making this notification.

Answer 11

Actively engaging a target or training the gun

Question 12

Poststrike: Rounds may remain in the __________, but will be cleared out of the ___________ that are attached to the feeder.

Answer 12

Flexible feed chutes; hard chutes

Question 13

If authorized during _______, the gun may remain loaded, but the manual safe handle will be in the Safe position prior to conduction refueling operations. During __________ the gun will be safe and clear.

Answer 13

Contingency operations; non-contingency operations

Question 14

If fuel vapor is detected in aircraft interior during refueling ________. Do not change electrical switch position until fumes are eliminated.

Answer 14

Disconnect and ventilate aircraft using smoke and fume elimination procedures

Question 15

AFT CARGO DOOR AND RAMP OPEN: Do not exceed _____ with the aft cargo door and ramp open. When operating with the cargo door open and the ramp closed, do not exceed_______.

Answer 15

250 KIAS; 185 KIAS

Question 16

PARATROOP AIR DEFLECTORS: Do not exceed ______ when operating the paratroop air deflectors or with the air deflectors extended regardless of whether the paratroop doors are open or closed.

Answer 16

150 KIAS

Question 17

PARATROOP DOORS: Do not exceed 150 KIAS while opening or closing the paratroop doors. Do not exceed 250 KIAS with paratroop doors open and locked.

Answer 17

True