Jeppensen Section G Flashcards

1
Q
  1. A voltmeter is connected in _______ with the voltage that is to be measured
A

ANSWER: Parallel

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q
  1. Very low resistance may be measured using a _______ type ohmmeter.
A

ANSWER: Shunt

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q
  1. Very high resistance may be measured using a(n) _______ .
A

ANSWER: Megohmmeter

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q
  1. When a short circuit is present, resistance is _______ and current flow is _______.
A

ANSWER:
Decreased,
Increased

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q
  1. A burned out light bulb will constitute a(n) _______ circuit.
A

ANSWER: Open

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q
  1. The two basic instruments used for electrical troubleshooting are:
A

A.ANSWER: Voltmeter
B.ANSWER: Ohmmeter

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q
  1. When using an ohmmeter to troubleshoot an electrical system, the system power should be _______ (on or off).
A

ANSWER: Off

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q
  1. When a voltmeter is placed across an open component in a series circuit, it will read ______ voltage.
A

ANSWER: Applied

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q
  1. When a voltmeter is placed across a good (not defective) component in an open circuit, the voltmeter will read ______.
A

ANSWER: Zero

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q
  1. Answer the following using the figure below:

a. A voltmeter reading of 24 volts between points C and H would indicate a ______ (good or bad) fuse.

b: A voltmeter reading of zero volts between points D and E would indicate a(n) ______ (open or
closed) switch.

c. A voltmeter reading of 24 volts between point F and H and a light that does not burn would indicate a(n) ______ (good or bad) bulb.

d. A voltmeter reading of 24 volts between points B and C would indicate a _____ [good or bad) fuse.

e. A voltmeter reading of zero volts between points of F and H and a light bulb that does not burn would indicate that the trouble _______ (is or is not) in the bulb..

A

ANSWER: Good

ANSWER: Closed

ANSWER: Bad

ANSWER: Bad

ANSWER: Is not

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q
  1. If a semi-conductor diode is checked with an ohmmeter set to the Rx 1 scale, and the readings are low when checked in both directions, the diode is ______ (open or shorted).
A

ANSWER: Shorted

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q
  1. The resistance of the secondary winding of a step-up transformer is usually ______ than the resistance of the primary winding.
A

ANSWER: Higher

How well did you know this?
1
Not at all
2
3
4
5
Perfectly