HMMS Flashcards
What is a primary difference between the SAL and RF missiles?
SAL tracks laser energy (passive)
RF tracks reflected RF energy (active)
When a M36 training missile is detected, all live missile on board the aircraft will display____ in the missile icon
NA
The fuse contains the ARM/SAFE device that arms a missile when its launch acceleration exceeds approximately____
10 G’s
The AGM-114Rs minimum arming distances is ____ meters
375 meters
The AGM-114K2 arms approximately _____ meters from the launching aircraft
181 meters
When the thrust of the missile exceeds____ to_____ pounds, the missile will launch from the rail
600 to 830 pounds
The AGM-114R missile thrust duration approximately 2.5 to 3.5 second and reaching a maximum velocity of
435 m/s or (845 Kts)
Which component of the M299 launcher contains a training missile emulator which replicates RF missile operation
Launcher electronic assembly(LEA)
Which MPD page allows the air crew to electronically arm the M299 missile launcher
WPN UTIL
What is the minimum altitude to launch a SAL missile
32 Ft
What are the normal pylon articulation limits when the missiles or rockets are actioned
+4° to -15°
A SAL missile that has not been coded will display an ___ inside the missile icon
L
RF missile that has an over temperature condition will display___ in the missile icon
OT
A Hangfire will display____ in the missile icon and the message HANGFIRE will be displayed in the weapon status section of the high action display for six seconds
MH
RF missile icons have a_____ instead of a straight line at the seeker
V
The SAL missile LOBL Constraints symbology +/- ____ degrees and is being driven by the_____ _____ in the crewmembers display
+/-20 / missile seeker
To prevent video washout by the missile exhaust aircraft should be oriented ____ to ____ towards the side from which the missile will be launched
3° to 5°
The ALT channel selection is only available after a_____ channel has been selected
Priority
The missile quantity defaults to____ for both channels if sufficient missiles are available of the selected warhead
3
The____ ____ button is used to maintain AGM-114R missile in a LOAL flight trajectory
LOBL INHIBIT (L5)
What is the tri-service PRF code range
1111-1788 (No 9’s or 0’s)
The AGM-114R missile main warhead default at power up for an armor with a fuse selection of
SQ (Discrete code of 1755)
What negative factor during target illumination will cause a laser energy to be mass within the target
Entrapment
What are the 3 LOAL trajectory modes in which the AGM-114R missile can be employed
DIR, FLAT, and LOFT
When the TADS LOS and the missile seeker LOS differ by more than____ degrees a BACKSCATTER message will be displayed in the weapons inhibit section of the HAD
2°
Which LOAL trajectory should be used to engage a bunker when firing an AGM-114R missile
FLAT
When laser designating a 5000 m target for the AGM-114R missile, that lasts____ of the seconds of the TOF is required to be on the target
6 Secs(terminal guidance)
The AGM-114R LOFT Constraints box is being driven in the crewmembers displayed by the____or____
Stored coordinate data(R6) or SEL LOS
The remote designator should not be displaced more than____ degrees in aid from the launch aircraft to target line
60°
Maximum autonomous designation range is limited by the
TADS ability to maintain the total laser spot on the target
During a remote designation employing the AGM-114K the remote designator must be positioned outside of the +/-___ degrees safety fan either side of the gunner shot line
+/- 43°
5 km engagement, the maximum separation between targets should not exceeded____ meters, with an____ second separation between missile launches
100 meters/ 8seconds
The ripple mode, after the primary channel missile is launched the alternate channel missile may be launched after____ second separation
1.5 sec
For an autonomous engagement, the aircraft should be oriented_____to_____to the side from which the missile will be launched
3 to 5°
The AGM-114L missile MODE selections are ____ in each crew station
Common
In the AUTO power mode missiles are powered up at_____ minute interval
10
2nd TARGET INHIBIT selection is used for engagements against_____ target only
Stationary
The RF missiles can overheat(OT) if it’s radiating(tracking) at target for more than______ minutes
3 min
With 6 AGM-114L missiles loaded the AUTO power mode selection will power up____ RF missiles
2
The AGM-114L allowable constraints is +/- ___ degrees when tracking the NTS target when the range is less than 1 km
5°
Name the three RF missile modes
STBY, Pre-Launch, and Post-Launch
Transfer alignment occurs in the_____ missile mode
STBY
In the pre-launch mode, what are the three methods of target handover to the RF missile
FCR, TADS, and IDM (RFHO)
Doppler beam sharpening(DBS) uses a curved trajectory to induce a relative motion for stationary targets(STI) hands are probability of detection and tracking between what ranges
2500-8000 meters
At a range of ____ to ____ meters, targets are too close for a LOAL engagement and a”NO ACQUIRE” message will be displayed
500-1000 meters
The three RF missile acquisition modes are_____,_____,and_____
Terminal track acquisition, pre-terminal track acquisition, and moving target acquisition
What inhibits can be overridden , and how is this accomplished
Performance, 2nd detent
Is the message” BACK SCATTER” a safety or performance inhibit
SAFETY INHIBIT
What does the message “ALT LAUNCH” mean
A rocket launch is in progress. Missiles are inhibited from firing for two seconds
What is the RF missile radiation hazard area to be avoided
1 meter 45°
When in training mode, all tactical missiles will display____ inside the missile icon
NA
The TME allows for thermal management of the missiles by allowing for cumulative time on of____ minutes
30 minutes
With the TRAIN mode selected in a weapon system is action the weapons inhibit field will display
Training
With the TRAIN mode selected and the missile system is actioned, the missile constraints box will display a _____ centered in the box
T
