Controls And Displays Check On Learning

Question 1

What position should the Multipurpose Display DAY/NIGHT/MONO switch be in when the crew wishes to to use the very lowest settings?

Answer 1

MONO

Question 2

What effect does pushing the MENU button have if not on the main menu page?

Answer 2

This will always bring up the MENU page

Question 3

Which switch is used to bring the FLT page to the left MPD by pushing in the ‘z-axis’ of the switch?

Answer 3

Symbology Select Switch

Question 4

What switch is used to action a weapon system?

Answer 4

Weapon Action Switch (WAS)

Question 5

What two ways can a crew member activate a cursor enter function using controls on the collective grip?

Answer 5

“Z” axis on cursor controller or alternate cursor enter

Question 6

Which switch allows a crew member to select HMD as the current line of sight?

Answer 6

The sight select switch

Question 7

Can the cursor be displayed on the TADS Display Unit (TDU) if TADS video is selected on the TDU?

Answer 7

No, only when FCR video is selected

Question 8

Which switch is used to change FLIR image polarity?

Answer 8

Sensor/Polarity Switch

Question 9

Which button will jettison all wing stores at the same time?

Answer 9

Emergency Jettison button on the collective flight grip

Question 10

What happens when the CHOP button is activated from either crew station?

Answer 10

The speed of both engines is reduced to IDLE

Question 11

Which crew member controls the exterior light settings on the aircraft

Answer 11

Pilot

Question 12

What component contains the APU push button?

Answer 12

Pilot’s Power Lever Quadrant

Question 13

What switch is used to slew the selected Night Vision System (NVS) to the Crew member’s helmet Line of Sight (LOS)?

Answer 13

NVS mode switch

Question 14

With the Master Volume knob rotated all the way to the minimum position, can the Master Warning and Master Caution audio be heard?

Answer 14

YES

Question 15

When is the VU2 radio Control Active?

Answer 15

Dual Engine Failure
Battery Power
VU2 TRAINING mode has been selected

Question 16

What two methods will activate the Keyboard Unit when the scratchpad is blank?

Answer 16

The KU becomes active by the selection of any KU button or when a MPD data entry button is selected

Question 17

Which component allows the pilot to adjust the Integrated Helmet and Display Sight System (IHADSS) brightness and contrast?

Answer 17

Video Panel

Question 18

What is the primary display device for viewing communication data?

Answer 18

Enhanced Up Front Display (EUFD)

Question 19

The VU2 Emergency Radio fails to power up. Where would you look to check the 28 VDC VU2 ARC-231 circuit breaker?

Answer 19

Circuit breaker panel no. 5 on the PLT center console

Question 20

What Video selections are on the TDU?

Answer 20

Target Acquisition and Designation System (TADS)
Fire Control Radar (FCR)
Pilot Night Vision System (PNVS)
Grayscale (C/S)