GoJet Flight Instruments Flashcards
Where are the reference speeds, MDA, DH and barometric altimeter settings entered?
On the Air Data reference Panel (ARP).
Pitot tubes P1 and P2 are pitot static tubes while pitot tube P3 is only a pitot tube.?
True
ARHS initialization takes approximately how much time on the ground and how much time in flight?
70 seconds/10-35 seconds
Where is the slip indicator located?
Below the roll pointer
When DME hold is selected, what is displayed/removed from view on the PFD?
An amber H replaces the green NM indication and the identifier for the VOR is removed.
What does the flight mode annunciator in the upper left corner of the PFD display?
Current active and armed Flight Director status
On the ground, how long can the EFIS tubes be operated without AC power?
5 minutes due to cooling degradation
What should be observed when the RA test button is pressed?
50 feet is indicated and the rising runway indicator appears.
What should be done to display TCAS information on the MFD?
Press the TFC button on the Display Control Panel.
What should the pilot do if their PFD display fails
Select PFD on the MFD display reversionary panel to display PFD information on the MFD
What should occur if the ED1 screen fails?
ED 1 screen will appear on ED2 automatically
With the failure of ED2, or the failure and automatic transfer of ED1, what happens to the EICAS Control Panel (ECP)?
ECP operation is inhibited and the status and synoptic pages are removed. It can be regained by using the MFD reversionary panel or the source selector panel.
If the only operative ED is displaying a status or synoptic page and a warning message is generated by the DCU, what should occur?
The operable ED will revert to the primary page and the warning message will be displayed
The color of the armed mode of the flight director is shown by a ___________ color on the PFD.
White
Warning messages will be shown as a ______ message on the CAS..
Red
