Engines Flashcards
Which rotor speed is indicated by N1?
Low pressure
What happens if the EGT exceeds the red line limit?
The maximum exceedance value attained will be displayed
How is the fuel flow normally displayed?
Both digital readout and pointer
What is the required minimum duct pressure for engine start using external air?
30psi
What indicates that the start valve has opened and; the air driven starter is turning the high pressure compressor
N2 increasing
When would the Engine Start Selector automatically move to AUTO?
50% N1
Moving the Reverse thrust levers from the reverse idle detent to the full down position causes the thrust reversers to do which of the following?
Return to the stowed and locked position
What does the Command Thrust Level display indicate?
Commanded thrust value
What is the position of the thrust reversers if the REV annunciations are green?
Fully extended
What happens when the Fuel Control Switch is placed to the CUTOFF position?
The engine and spar valve close
How is the engine oil display affected when engine oil pressure reached the red line limit?
The display changes colour to red
With the STARTER CUT OUT message displayed on EICAS and the start selector in ground, what would you do first?
Move the start Selector to AUTO
When will the inflight start envelope be displayed?
When an engine is shut down inflight and the secondary engine display is in view
After landing, when can the Reverse Levers be raised to the interlock stop?
When the thrust levers are at the idle position
How can the LEFT engine starter be isolated from the external pneumatic supply with the starter stuck open?
Direct the external air source be disconnected
