Emergency Procedures Flashcards
Should a steady warning horn sound in flight what would it indicate and what actions?
Not in correct landing config, correct config
Should an engine surge or stall be identified what are the first actions?
Disconnect A/T, Retard thrust levers until indications are within limits or lever is closed (confirm correct engine)
Should a stab runway occur and disengaging the autopilot doesn’t stop the runaway what’s the next step?
STAB TRIM CUTOUT switch to CUTOUT
In the event of airspeed unreliable, following A/P+A/T disconnect and F/Ds off, what pitch thrust settings are required flaps UP and flaps NOT UP?
UP: 4deg / N1 75% / NOT UP: 10deg/ N1 80%
If engine overheat is indicated what are the first actions?
Disengage A/T, Confirm, close effected thrust lever
Engine Fire Switch fails to unlock, how can it be pulled?
Pressing the override button under the switch
What is the memory item for an aborted engine start?
Start lever to CUTOFF
Should an intermittent warning horn sound in flight, what does this indicate and what is the initial procedure?
Excessive cabin altitude, don oxygen masks and establish comms
Should it become necessary to abort an engine start, what is the first memory item?
Move the engine start lever to CUTOFF
What are the first two memory items that should be completed if loss of thrust on BOTH engines?
Engine start switches to FLT, Engine start levers to CUTOFF
In the event of smoke or fumes in the flight deck, first action?
Don Oxygen masks and set regulators to 100%
If an evacuation is ordered what are the first two actions required by Captain?
Set parking brake and lower the speed brake lever
If an APU fire is indicated what are the first actions?
APU fire switch, pull an rotate, APU switch off
With the engines operating, what memory items are required in the event engine indications are rapidly approaching or exceeding limits?
Disconnect A/T, Retard thrust lever until inidcations are within limits or thrust lever closed
With crew oxygen masks donned how does the crew activate the microphone in the mask
The switch on the ACP is turned to MASK