ECS System Flashcards

1
Q

What happens to the outflow valves upon touchdown?

A

they go full open

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

If one outflow valve is in manual, will the other outflow valve operate in auto?

A

yes

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Where/When can I observe cabin altitude and rate, landing altitude, and differential pressure?

A

Primary EICAS when:

  • landing altitude in manual
  • cabin altitude in caution or warning
  • cabin differential pressure in caution or warning
  • ECS or ENG selected on lower EICAS
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Is there auto switching of cabin altitude controllers if one should fail?

A

yes

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

When does the cabin altitude waring siren sound?

A

excessive cabin altitude (greater than 10,000 ft)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What is the max allowable cabin differential pressure for takeoff and landing?

A

0.11 PSI

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

What is the max differential pressure?

A

9.4 PSI

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

How many positive pressure relief valves are there nd where are they located?

A

2 in E&E compartment (left front compartment)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Where are the negative pressure relief valves located?

A

side cargo door and forward and aft cargo doors

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is the temp range for the flight deck?

A

18C-29C

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What does the manual position of the temperature controllers do?

A

sets the trim air valves manually

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What will cause a zone system fault light to illuminate?

A
  • temp zone duct overheat
  • zone temp controller fault
  • master trim air valve closed
  • trim air switch off
  • master trim air valve closed and pack air still flowing
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What will cause a pack system fault light to illuminate?

A
  • pack ovate or other system fault

- may illuminate briefly while switching between controller (auto or manual)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What happens when you press the trim air switch to off?

A
  • master trim air valve closed
  • pack output temp in backup as selected by Flt. Deck selector in auto
  • no control of flight deck, upper deck, or main deck
  • pack controller A only
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

On the ground, engines not running, where is Equip. Cooling exhaust air routed?

A
  • into the lower forward cargo compartment when temp
    < 7C
  • ducted overboard when temp > 7C
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

What happens to the Equip. Cooling system on the ground when engines are running?

A

configures for flight, closing the outboard exhaust valve, venting the air into the lower FWD cargo compartment

17
Q

What does the STBY position of the Equip. Cooling system do?

A

manually configures the aircraft for flight

18
Q

What does the OVRD position of the Equip. Cooling system do?

A

the fans are deactivated and the air is vented overboard using cabin differential pressure