DETERMINING AGGREGATE CORRECTION FACTOR

Question 1

1/_

How much of the bowl do you INITIALLY FILL WITH WATER?

Answer 1

1/3 with water

Question 2

_ inch(s)

How much do you rod (penetrate) the top of the mix at a time?

Answer 2

1 inch

Question 3

8-_

How many times do you tap the sides AFTER RODDING?

Answer 3

8-12 times AFTER RODDING

Question 4

You __ after you finish EACH the filling, rodding, and mallet procedure of the measure to REMOVE ANY TRAPPED AIR BUBBLES.

Answer 4

Stir

Question 5

First step after clamping on pressure meter lid?

Answer 5

Add water through petcocks to flush out air.

Question 6

What is the next step AFTER ADDING WATER TO PETCOCKS?

Answer 6

Attach a spray tube to one petcock.

Question 7

Do you close the other petcock AFTER ADDING THE SPRAY TUBE TO ONE PETCOCK?

(YES OR NO)

Answer 7

YES

Question 8

What is the next step after adding the flow tube to one petcock AND closing the other petcock?

Answer 8

Pump the meter up to the IP line.

Question 9

What do you do after pumping of the meter to the IP line?

Answer 9

Release the main release valve

Will collect water from inside the pressure meter.

Question 10

What do you do after draining the initial water from the measure?

Answer 10

Repump meter to the IP line.

Question 11

What do you do after you REPUMP the meter to the IP line?

Answer 11

Release pressure via main valve and hit meter with hammer smartly

Question 12

When do you know the direct ready of the ACF

After you WHAT?

Answer 12

Release air from main valve and hit measure with hammer smartly

Question 13

Same ass mallet consolidation.

How many times do you ROD each lift of the measure?

Answer 13

8-12 times