Chapter 21 Flashcards
Coolant exchange machines can perform the following functions except.
Filter the coolant of impurities.
If the warning light comes on during driving or the temperature gage goes into the red danger zone, then the coolant temperature is most likely.
120 degrees Celsius to 126 degrees Celsius
The power train control module PCM in a vehicle commands the high speed fan when the Ac refrigerant pressure exceeds
240 psi.
In series flow cooling systems, blank in the gasket, block, and head perform the function of letting out the steam
Bleed holes
The boiling temperature of the coolant will most likely increase by blank for each pound of increase in pressure
3 degrees Fahrenheit.
In blank radiators the coolant flows from one side of the radiator to the opposite side
Cross flow
The blank must allow the engine to warm up to the required operating temperature as rapidly as possible and then maintain that temperature.
Cooling system
The power train control module PCM in a vehicle commands low speed fans on under the following conditions except when the System voltage is less than
12 volts after the vehicle is shut off
Sticky hydraulic valve lifter plungers is most likely a high temperature engine problem?
true
opening of rated thermostat and its operation
The rated temperature of the thermostat indicates the temperature on which the thermostat starts to open.
water pump type
Water pumps are not positive displacement pumps
coolant recovery systems A vacuum valve allows coolant to reenter the system.
true
Technician. A stated that when the cooling system cools the pressure in the cooling system is reduced and a partial vacuum forms
True
Technician b stated the vacuum pushes the coolant from the plastic container back into the cooling system keeping the system full
True
technician a stated that he coolant is passed through tubes in the small core of the heater.
True
Technician b stated. The air is passed across the heater fins and is then sent to the passenger compartment.
True
Which of the following is an appropriate precautionary measure when the coolant temperature warning light comes on?
The radiator cap should not be removed when the engine is hot.
Which of the following is a common cause of overheating in an engine?
Broken fan drive belt.
flusing the cooling system steps
When flushing the cooling system and engine should be started until reaches operating temperatures with the heater on.
Technician a stated that when installing and checking belt tension the belt should be installed on the engine and should be operated with all the accessories turned on.
True
technician b stated that when checking belt tension, a beam type torque wrench should be used to determine the torque needed to rotate the tensioner.
True
What can be done to prevent air from getting in the cooling system when the coolant is replaced
use a Coolant exchange machine.
The upper radiator hose collapses when the engine cools what is the most likely cause?
Defective radiator cap.
Heat transfer is improved from the coolant to air when the
Temperature is great