CH - Pattern Work

Question 1

OVERHEAD BREAK

Answer 1

1. ´R/T - BDXX, Initial, Left/Right (Stop)´
2. Wind - Crab
3. Lookout - up left/right (PFL TFC)
4. End of RWY - Break
   A) 60/2, PCL - Idle, 5sec Trim
5. 3/4 turn - PCL spool up
6. Roll out - Spacing,Tk, Tq adjust for 140kts
7. X< 147kt - configure
8. Lookout - extended RWY center line
9. Trim for 120 kts
10. Perch - flaps land, N down, 45AOB, PCL 20%
11. 1/4 turn - R/T ´BDXX, 3 Green, Go(Stop) left’
12. 1/2 Turn - ALT 2600ft
13. [+] - 120 trim, N up for 120
14. Aim point - Airspeed - Trim

Question 2

Fly through

Answer 2

1.Continue End of RWY
2. End of RWY - Turn Crosswind
3. Lookout- TFC Downwind
4. Turn - Downwind

Question 3

Low Approach Left/Right, Right/ In between

Answer 3

1. Maintain RWY center line
2. Alt - 2100ft
3. Speed 120 - Tr 35% or 55%
4. Go Around

Question 4

closed pattern

Answer 4

1. Clean up
2. R/T – BDXX, Closed left
3. Lookout, 140kts, End of Rwy
   a. Pull 10° N↑ UP, 45/2, Max 90°
4. 2700ft – PCL 20% tr
   a. Let nose drop - 3000ft intercept
5. 3000ft – Freeze 60/2
6. Anticipate Roll out
7. Roll out – Spacing, Tk, Tq 20%

Downwind
1. Circuit Check – Fuel, HYD Press, T’s & P’s
a. R/T – ´BDXX, Downwind (Stop)´
2. < 147 kts – Configure
3. Pre-Landing Check
4. Trim - 120 kts, 35% torque
5. Lookout – Downwind killer
6. Perch – Flap land, N↓, 30°-45° AOB, PCL 20%
7. R/T – ´BDXX, 3 green, Go left´
8. Halfway – 2600ft MSL
9. Window – 20%, 120kts, 2200ft
10. Airspeed – Aim point (Cycle)