Air Conditioning and Pressurization Flashcards

1
Q

In the aircraft pressurization system, what does the Amber LO
^p light indicate?

A

The pressurization system cannot keep up with descent rate of
aircraft

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What would cause the blue RATE light on the overhead

pressurization panel to illuminate?

A

The cabin pressure rate knob is out of the NORM position

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What air conditioning malfunction could cause an amber pack

FAULT light?

A

A pack overheat or valve position disagreement with selected

switch position

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What are the different levels of Air Conditioning Pack flow?

A

Normal or ECON

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

In the Air Conditioning System, what is the purpose of the

ECON pushbutton switch?

A

Reduces airflow inflight to 68% normal flow (both engines

operating) to increase fuel efficiency.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What is the primary purpose of the Pack Valves in the Air

Conditioning system?

A

They function as both a shutoff valve and a flow control valve

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

In the Air Conditioning System, what is the purpose of the

MAX COOL pushbutton switch?

A

Lowers the lower limit of the pack discharge temp

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

On the overhead air conditioning panel, if the compartment

temp function is selected to CRT, what happens?

A

All compartment temperatures can be read on ECAM

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

How many automatic cabin pressurization systems are

installed?

A

2 systems, one active and one in standby

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

When does the pressurization system automatically switch

controllers?

A

At 2nd engine start or when active system fails

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

In the Pressurization System, how many motors are installed

on each outflow valve?

A

Three, (Reg 1, Reg 2, manual)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

If one auto pressurization controller is deferred and the
remaining one fails, how would the crew control aircraft
pressurization?

A

Selecting the faulted controller OFF will force the

pressurization system into manual control

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

In the Air Conditioning System, what is the purpose of the

RAM air?

A

Used to ventilate cockpit and cabin in case of dual pack failure

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

In the aircraft pressurization system, what is the purpose of
the Safety valves?

A

Protect against over or under pressurization of the aircraft

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

How many temperature zones are there in the Air

Conditioning System?

A

Four – Cockpit, FWD cabin, MID cabin, Aft cabin

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

With both Air Conditioning packs operating, what is the pack

outlet temperature control priority?

A

If the Flt Deck demands coldest temp, it controls pack 1

17
Q

In the aircraft pressurization system, what automatically

occurs when both outflow valves are selected OFF?

A

Ditching mode is activated

18
Q

In the Air Conditioning system, how are the lower FWD and

AFT cargo compartments heated?

A

Indirectly heated by upper deck air, BULK cargo compartment

is directly heated

19
Q

When would the Vent Overboard Valve normally be fully

open?

A

On the ground, no engines running

20
Q

What occurs if the EXTRACT pushbutton on the VENT

overhead panel is pressed in-flight?

A

OVBD light illuminates white and Overboard Valve partially

opens, increasing the rate of ventilation

21
Q

What does the air conditioning system supply to the Bulk

Cargo Compartment?

A

Trim air plus air extracted from the main deck

22
Q

What three conditions will cause the residual pressure red

warning light to flash?

A

Cabin pressure is present, at least one engine is shut down and
the emergency evacuation slide is disarmed

23
Q

What is the purpose of the RAM air system?

A

Used to ventilate cockpit and cabin in case of dual pack failure

24
Q

What occurs if the VENT EXTRACT pushbutton is pressed inflight in response to a VENT EXTRACT LO FLOW ECAM
message?

A

OVBD illuminates white and the Overboard Valve partially

opens

25
What is the primary function of the Precooler?
Controls temperature of the engine bleed air entering the | bleed air manifold
26
Where can hot air for the air-conditioning system be supplied from?
The engine(s), APU or a ground air cart
27
When you select the MAN PRESS switch, how does it affect | the aircraft pressurization system?
The system is selected to manual, the V/S Switch becomes active and the ECAM pressurization display and the Cabin High Altitude warning are both lost
28
In the Air Conditioning system, what supplies the air for the Hot Air Manifold?
Hot compressed bleed air tapped off prior to the packs
29
Where is the cold air from the Air Conditioning Packs sent?
Cold Air Manifold
30
With only one Air Conditioning pack operating, what controls | that pack’s outlet temperature?
The operating pack outlet temp is controlled by whichever | zone (cockpit or main deck) that requires the coolest air
31
In the air conditioning system, what is the function of the | Pack Temp MAN CTL selector?
Manual control of the Pack discharge temperature when MAN | is illuminated white in the Pack MODE SEL pushbutton
32
During normal operation, what does the active pressurization | system control to maintain cabin pressurization?
Outflow valves
33
In the Air Conditioning system, what component mixes air | from the Hot and Cold Air manifolds?
Trim Air valve