Brainscape's Knowledge GenomeTM

Browse over 1 million classes created by top students, professors, publishers, and experts.


See full index

Log Books - Newman > 2006/2009 American LaFrance > Flashcards

2006/2009 American LaFrance Flashcards

1
Q

2006/2009 Cat C-13

Engine Oil Pressure Normal Operating

Range ___ psi (min) @ idle _____ psi @ rated rpm

A

10

30 - 45

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

2006/2009

Engine Coolant Temperature Normal Operating Range

____ to _____ F Max. ___ F

A

190 to 208 F

219 F

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

2006/2009

Engine Fan Clutch Engagement ____ F

A

208 degrees

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

2006/2009

Transmission Fluid Temperature Normal Operating Range _____ to ______ F

A

160 to 200

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

2006/2009

Caterpillar ____ BHP, ___ Liter, C-13 Electronic Control

A

525

12.5

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

2009 ONLY!!! Alarm by shoreline plug in

Voltage Monitor with Alarm

Alarm activates when the electrical system voltage drops below ___ volts. Once activated, the alarm will not deactivate until the system voltage increases by ___ volt.

A

11.8

1

2000 - 2009 An alarm sounds if a low-voltage condition (below 11.9 volts) develops, and the Officer’s Information Center displays a message that the Load Manager system is in control.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

2006/2009

The ignition switch is a “rocker” style switch that when closed, allows current to flow to specific electrical accessories.

A

reference

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

2006/2009

Battery Master Power

The battery switch is used to disconnect electrical power to the apparatus to prevent discharge while the apparatus is not in use. Power to the Kenwood and 800 radios are also cut when the battery master switch is turned to the OFF position. The one exception to this is the MDT (Mobile Data Terminal). The MDT will continue to draw electrical current (approximately 7 to 8 amps) even though the battery master switch is turned OFF.

A

reference

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

2006/2009

Intermittent Wiper Control

The intermittent delay interval is adjusted using the intermittent wiper control. Slide the control knob all the way down for the maximum delay between wipes. Move the control knob up to decrease the delay. With the knob all the way up, the wipers operate continuously at low speed. If the wiper switch on the turn signal lever is
toward the LO position, the wipers will operate at low speed, overriding the intermittent delay feature.

A

reference

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

2006/2009

Low Oil Pressure/High Water Temp: Illuminates when oil pressure falls below ___ PSI or water temperature rises above ___ F.

A

12

230 degrees

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

2006/2009

Air Cleaner Restriction Gauge

Maximum restriction at full-load and governed rpm is ___ in. H20 and maximum restriction at no-load and governed rpm is ___ in. H20.

A

25

15

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

2006/2009

Windshield Wiper Switch

Activates windshield wipers. The switch has two positions that enable two different wiper speeds.

A

reference

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

2006/2009

Accessories Up Indicator Light

Illuminates when the aerial ladder is not bedded.

A

reference

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

2006/2009

Used to adjust the temperature of the tiller cab heater (Low 2900 BTU, Medium 4100 BTU and High 6150 BTU).

A

reference

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

2006/2009

Tiller Cab Safety Belt Attachment Point

Location where the safety belt attachment buckle is connected (used for tiller training).

A

reference

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

2006/2009

The Caterpillar, C-13, is a six-cylinder valve-in-head type engine. It has a 5.12” bore and a 6.18” stroke, with a total piston displacement of ____ cubic inches and a compression ratio of __ to 1.

A

763

17 to 1

17
Q

2006/2009

The C-13 develops its highest torque, ____-ft lbs. at ___ RPM and its rated horsepower, ____ at ____ RPM.

A

1650 ft lbs at 1800

525 at 1800

18
Q

2006/2009

C-13 Operating range is ____ to ____ RPM.

The best fuel economy is delivered between ___ – ___ RPM.

A

1200 to 2100

1200 - 1800

19
Q

2006/2009

The Caterpillar C-13 engine is equipped with an electronically controlled fuel injection system. There are no control racks or mechanical linkage to adjust. This system not only helps to improve fuel economy and vehicle performance, it also helps to reduce cold starting time and increase initial idle speed for fast engine warm-up and virtual elimination of cold smoke.

A

reference

20
Q

2006/2009

The C-13 engine has no mechanical governor. Engine horsepower, torque, idle and engine speed is contained in the internal electronics. The Electronic Foot Pedal Assembly eliminates the need for any throttle linkage.

A

reference

21
Q

2006/2009

GEAR RPM SPEED
1 2100 ______
2 2100 ______
3 2100 ______
4 2100 ______
5 2100 ______

A

14

26

35

50

68

22
Q

2006/2009

If the engine fails to start within 15 seconds, release the starter button and allow the starting motor to cool for approximately 15 seconds before trying again. If the engine
fails to start after four attempts, an inspection should be made to determine the cause.

A

reference

23
Q

2006/2009

A good indicator that all of the moving parts are getting lubrication is when the oil pressure gauge registers pressure (at least 10 psi) at idle speed. If there is no oil pressure indicated within 10 to 15 seconds, stop the engine and check the lubricating system. The pressure should not
fall below ___ psi at 1800 rpm (Caterpillar).

A

30

24
Q

2006/2009

The electronic foot pedal assembly was designed to communicate “percentage” of foot pedal travel to the engine’s electronic control module. The engine will respond accordingly to the driver’s demand.

A

reference

25
Q

2006/2009

C-13 Oil with filter and without filter

A

42

38

26
Q

2006/2009

Tire Pressure

Front ____

Duel _____

Tiller _____

A

100

95

115

27
Q

2006/2009

Leece-Neville LN 4962PA ___ amp Pad Mount Alternator

A

320

28
Q

2009 only

An indicator of the pad wear is available by inspecting the floating pins on each axle. When the pads are new, the floating pin will be exposed approximately ___ to ____”. When the pin is sticking out ___”, the pads are worn to replacement condition. Call the shops once the floating pin is sticking out 1⁄4” or less.

A

3⁄4”to 1”

1⁄4

29
Q

2006 2009

Height (max.): Top of Tiller Cab –

A

2006 - 11’ 1”

2009 - 11’ 3”

30
Q

2006/2009

Height: Top of Cab Roof -

A

10’

31
Q

2006/2009

Height: Cab Full Tilt Position ___

A

15’ 6”

32
Q

2006/2009

Width (including mirrors) ____

A

9’ 5”

33
Q

2006/2009

Apparatus Average Weight (Fully Loaded Including Personnel) _____ lbs.

A

60,090 lbs.

34
Q

The steady red light switch activates two red light located where?

A

Front grille

35
Q

The ABS light will illuminate when?

A

There is a fault

36
Q

Air wik system, when filling with water can add what solution?

A

Foam concentrate only

Log Books - Newman (16 decks)

Brainscape helps you reach your goals faster, through stronger study habits.
© 2024 Bold Learning Solutions. Terms and Conditions