Vehicle Disentanglement

Question 0

We should always treat the areas around airbags as if they have not deployed. We should remain at least ____ inches from side airbags
____inches from driver airbags
____inches from passenger air bags

Answer 0

5 side. 10 driver. 20 pas.

Rule of 5-10-20

Question 1

At vehicle extrication the eng off should divide members into 2 teams. The off and 2 cfrd trained members proceed to the scene of the accident. What do the remaining members do?

Answer 1

Stretch and charge a precautionary handline

Question 2

For ladder company ops at a vehicle accident, Who should ensure the battery is disconnected?

Which terminal first?

Answer 2

The officer

Negative

Question 3

Before any vehicle stabilization methods are taken what should be checked?

Answer 3

Under the vehicle for victims

Question 4

When a vehicle is encountered on its side or roof no members should enter it until it is properly stabilized. A good initial choice for entry could be the front or rear windows.
T/F

Answer 4

True

Question 5

When performing total roof removal during veh extrication you would cut low on the \_\_\_\_ post and high on the rest. 
A
B
C
D

Answer 5

A

Question 6

When using the sawzall to cut a windshield what blade is used?

Answer 6

Wood cutting

Question 7

When using the spreaders for dashboard displacement, make 2 cuts in the bottom of the a post. The lower cut is made below the hinge parallel to the rocker panel. The second cut is made ~_____ inches above the 1st
A. 2-4 B. 4-6 C. 6-8 D. 8-10

Answer 7

C

Question 8

Fabric blankets are a better choice than salvage plastic or yellow exposure blankets when protecting victims from broken glass.
T/F

Answer 8

False

Salvage plastic and yellow exp blankets are a good choice

Fabric blankets are not a good choice.
Glass stays in fabric and they must go OOS when contaminated

Question 9

The blade of a windshield saw is installed correctly when the blade faces the handle of the tool.
T/F

Answer 9

True

Question 10

If you decide to cut a hole in the roof of a vehicle on its side what would the tool of choice be?
A. Air chisel
B. Sawzall
C. Power saw with aluminum oxide blade 
D. Hurst tool cutters

Answer 10

A

Question 11

When using spreaders and cutters always remove the _____hinge first.

A. Top
B. Bottom

Answer 11

A

Question 12

If a member gets hydraulic fluid in their eye they should flush it with water for at least____minutes and immediately seek medical attention.

Answer 12

20

Question 13

In a vehicle with an automatic rollover protection system that can be manually deployed, manually deploying it would be the course of action.
T/F

Answer 13

True