Training Bulletin 38 Reciprocating Saw

Question 1

According to training bulletin 38 reciprocating saw, what is the cutting limitations in wood and metal as well as the SPM

Answer 1

Wood up to 12”
3/4” metal
0-2600 SPM

Question 2

When cutting with the tiger saw, when cutting metal, a minimum of how many teeth shall contact the metal and at what SPM?

Answer 2

Minimum 3 teeth at a lower SPM

Question 3

When using the tiger saw at a vehicle extrication, what blade shall be used and how many teeth per inch does it have?

Answer 3

960R, 10 TPI

Question 4

When using the tiger saw to make a plunge cut, what position should the selector knob be placed in?

Answer 4

Orbital

Question 5

How long is the power cord of the tiger saw?

Answer 5

9.5 feet

Question 6

If a blade brakes in the tiger saw, what can you use to remove the broken piece?

Answer 6

Another blade

Question 7

How can the pivoting guide shoe of the tiger saw be adjusted?

Answer 7

2 hex set screws located in the bottom of the rubber front housing

Question 8

What material should not be plunged when using the tiger saw?

Answer 8

Do not plunge cut metal

Question 9

Cutting post on a car can be cut ___ or ___ than cutting with the holmatro

Answer 9

As fast or faster

Question 10

When using the tiger saw to remove the roof of a car, what is done to the windshield?

Answer 10

It is left in place. Do not cut with tiger saw

Question 11

What should not be used to clean the tiger saw?

Answer 11

Solvents

Question 12

When writing a F-175 tag for a 1 for 1 exchange of a tiger saw blade, what should be written on the tag?

Answer 12

The teeth per inch of the blade