Switch Logic Flashcards
WIPERS
• Rain RPLNT
• Wiper
- Rain RPLNT—Measured amount applied to windshield (inhibited on ground and engine stop)
- Wiper—Off/Slow/Fast
CALLS - MECH
• Pressed and held
• Released
- Pressed and held—lights up blue external light/ HORN
* Released—Horn silent, light stays lit until reset
CALLS - FWD/AFT
- High/Low Chime
- 2 lights come on in area call panel
- Attendant Indication Panel–Captain Call Message
Appears with green light
CALLS - EMER
When Pressed in cockpit:
- Two pink lights flash all area call panels
- EMERGENCY CALL on all AIPs
- HIGH/LOW Chime 3 times
- ON flashes CALL Flashes
When Pressed in cabin:
- ON flashes CALL Flashes
- ATT light flashes on all ACPS
- 3 buzzers for 3 seconds each
OXYGEN
MASK MAN ON
Normally auto deploy at 14,000
• If PRESSED Mask Door Open Signal Sent
OXYGEN
PASSENGER
Comes on when oxygen mask controller active, reset on MX panel
OXYGEN
Crew Supply - ON/OFF
- ON—Valve is open and Low Pressure O2 to masks
* OFF— Valve is Closed,White Light Comes on (Amber O2 quantity on DOORS page)
RCDR
GND CTL - ON/AUTO
- ON—Can Energize the CVR, Blue light comes on
* AUTO— lights out, CVR Energizes during first 5 minutes after power applied, one engine on the ground, in flight
RCDR
CVR ERASE
Pressed for two seconds on the ground/PB o/ erases tape
RCDR
CVR TEST
Tests the CVR(GND CTL ON—or CVR Energized— PB on)
GPWS
TERR - ON/OFF/FAULT light
- ON—EGPWS Provided (Terrain Awareness Display and Terrain Clearance Floor) Geometric Altitude
- OFF—Inhibits (see above) Does not affect mode 1-5, ECAM Caution NAV GPWS TERR DET FAULT
- FAULT Light— Fault in TAD or TCF (terrain not shown on ND)
GPWS
SYS - ON/OFF/FAULT
- ON—GPWS Generates Normal Warnings
- OFF—All Modes 1-5 inhibited
- FAULT—Amber Light & ECAM Caution Fault in any of the 5 modes (Unless mode ILS 1 fails/ then only mode 5 fails and no light)
GPWS
G/S MODE - ON/OFF
- ON—Mode 5 is active
* OFF—Mode 5 Inhibited
GPWS
Flap Mode - ON/OFF
- ON–Mode 4 is active
* OFF—Inhibited in case of landing reduced config.
GPWS
LDG FLAP 3
• ON—Lights Out Normal
• ON:—Flap mode inhibited for Config 3 LDG
MEMO displays Config 3 instead of Config FULL