Removable Bollard OPS Tool 35 Flashcards
Who carries the Custodian Bollard wrench?
2
Engine 15.
One wrench is assigned to Engine 15 and another is available at their quarters for the use by relocated units.
Which wrench is bigger the Custodian Bollard wrench or Custodian hydrant wrench?
Two
The custodian Bollard wrench is slightly smaller
What tool can you use to remove the metal boliard? Photo 8
Metal Halligan hook
Retractable Bollards. Electronically retract into the ground and operate by a key switch. Sets of keys will be issued to first due units in these areas at the direction of the.———?
3
Public Transportation Safety Unit otherwise known as PTSU
In case of power failure, the Bollard system is included with a battery backup, which allows for approximately — cycles of raising and lowering. There is no manual override option on the retractable bollards.
3 page 6
10 cycles of raising and lowering
In case of power failure, the bollard system is equipped with battery backup which has two key switches in inside control box which one is used by FDNY for emergency use only. Page 6.
Top is for FDNY use only.
Bottom is for DOT use only.
To lower the bollards, member approaches control box and unlocks control box door by inserting a key marked —- and turning ———-. Depress the button and use the handle to open the door.
Is the control box door spring loaded?
3.1
RB (in the pic it is RB50)
Counterclockwise
Door is spring loaded ( will not stay open)
Bollards.
Control box outer key ——?
Inner key use the key marked ——?
3.1
RB ( in the pic RB50)
EM. (In the pic EN50)
Bollards. The member inserts the key marked EM into the upper key switch and turns the key to the EMERG position to lower the Bollards The Bollards will lower and the strobe light will flash continuously while the bollards are in the lowered position. 3.1 page 8.
True
T/F when operating the Bollards a member must be assigned to the control box throughout the operation. The key is removable while in the emergency position.
3.1 page 9
False
The key is not removable while in the emergency position. Keys must not be left unattended in the key switch at anytime.
Bollards. There is a tamper alarm on the control box. It does not transmit to DOT operation center. If the key is not placed in the switch and turned within —- after opening the control box door, this system will switch to Taper mode. Page 9.
30 seconds
Causing the alarm to sound and power to automatically be cut from the system. Likewise, the alarm will activate the control box door if not closed within 30 seconds of removing the key from the key switch.
Bollards. To reset the alarm insert the key into the key switch and turn towards reset. Be advised the key will not remain in reset position, but will spring back to —- position.
Page 9.
NORM position
Bollards.
A lost or stolen wrench or key requires immediate notification to? 4.2
PTSU or telephone notification
(Either email or phone)
Lost property Report
Police report
Through Chain of Command with copy to PTSU
