Red Seal Prep Flashcards
When cutting a pocket that supposed to be .550” and it measures .545”, what shoud be done?
Adjust tool height offset.
Why is a grinding allowance left on the workpiece prior to heat treatment process
Accommodate for material distortion
Which product is used to check the final taper fit of mating parts?
Prussian Blue
Which type of thread series is used to achieve a pressure Tight Seal
Npt
What process is used to achieve a spot face
Machining a flat surface that is perpendicular to the axis of a hole
Which accessory is used to remove taper shank from the drill press spindle?
Drift
Which part of a lathe threading mechanism determines how fast the carriage travels
Lead screw
When turning a taper on a lathe where is the point of the cutting tool edge of the tool set
On center
An eccentric is required on the end of the shaft how is the workpiece setup
By laying out the eccentric holding in a 4 jaw Chuck aligning the tailstock centre and verifying with a dial indicator
Where is the arbour support located when setting up a horizontal milling machine
As close to the cutter as possible
How far is the centre line of the spindle from the edge of a workpiece when using a .200” diameter Edge finder?
.100”
When heat treatment is required why are key seats in a shaft machine with a radius
To prevent cracking
how is a 1 inch diameter bored hole with a tolerance of plus or minus .001 measured
Telescoping Gauge and micrometer
Which component is adjusted on a vertical bandsaw to cut an angular surface
Table
Which surface is required to be ground when when sharpening a plain Milling cutter
The periphery
In CNC Machining what is the term used for a set of instructions or blocks that can be inserted into a program and repeated when required
Subprogram
What is the drill tip compensation for a standard 1/2 inch twist drill?
.150
In CNC Machining which rotational axis revolves around the spindle
C axis
Which of the following statements is true for a National Occupational analysis NOA?
The NOA is the soul document used to develop a red seal exam
Which of the following statements accurately reflects the steps required to produce a red seal exam?
Hrsdc convenes a workshop of Industry practitioners to develop an NOA, hrsdc collects and reviews all comments related to the draft from the NOA, and then hrsdc develops an exam plan
Industry practitioners are people that work Hands-On in a trade. T or F?
True
What are the three types of questions used on Red Seal exams?
Recall, application and critical thinking
Why is it important to obtain a red seal endorsement?
The Red Seal is the industry accepted standard for excellence in a trade
What is the best way for an apprentice to learn?
Mentoring and coaching
Who is responsible for training material?
PAC and LAC
What is the federal government’s role in the red seal?
Regulate the red seal exams.
