Power system design part 2 Flashcards

1
Q

Have you used a Computer software used in Power analysis? Is so, what program was used?

A

No, but one is IPSA, Interactive Power System Analysis

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What do we mean with load flow analysis

A

Initial before any analysis – which identifies capability, voltage, power flow, load angles.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What do we mean with fault analysis?

A

Whether your system will be able to withstand faults when occurs in 1, 3 seconds.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What do we mean with harmonic analysis?

A

How clear is your sine wave (8%) max total harmonic disturbance allowed.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What could happen to the Power system when starting large motors?

A

Voltage drop due to high starting current.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Which basic document is used when starting/setting up a Power System Analysis?

A

Load Schedule.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

When would you require to do a (new) Power System Analysis?

A

Addition of a major load

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

How would you organise or set up a Power System Analysis?

A

Flow chart required, data from vendor, impedance, transient, sub transient and synchronous impedance.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What are important Electrical System Parameters?

A

Frequency, voltage, Power, Power Factor, governor, AVR

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

How do protections grade? Where do we start?

A
  • Protection systems shall be selective and the settings shall be co-ordinated so that back-up protection is provided to initiate fault clearance in the event of protective system and/or switching device failure.
  • In zones, From source
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What is the importance of minimum and maximum short circuit levels in relation to protection studies?

A
  • Is it enough to operate your protection system.

- Should not be achieved to trip before that.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What type of protection would you use on a delta/star transformer connected as a unit transformer for a generator?

A
  • Differential.
  • Vector difference to be compensated.
  • Stability through fault current should not operate.
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What is the relation between Power System Analysis and protection Co-ordination?

A

Power system analysis will provide fault level, stability and data for protection co-ordination.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

How can you as Electrical Engineer influence the design?

A

Specs are followed and integrity is not compromised.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly