Phenom 300 Powerplant/ Oil

Question 1

What is the engine make and model?

Answer 1

PW535E

Question 2

What is the engine rated thrust?

Answer 2

3360 up to 30 C

Question 3

What components are mounted on the engine’s accessory gearbox?

Answer 3

• Hydraulic Pump
• Fuel Management Unit (LP/HP pumps)
• Oil Pump
• Starter/ Generator

Question 4

Which start malfunctions are protected by the FADEC with automatic abort during weight on wheels, and what are the automatic abort criteria?

Answer 4

• Hot Start - Half the difference between ITT transient and steady state limit
• Hung Start - Time to reach idle exceeds 60 seconds from fuel command
• No Lightoff - ITT not raised significantly 10 seconds from fuel command

Question 5

When is start protection inhibited?

Answer 5

Weight off Wheels

Question 6

How is the FADEC normally powered?

Answer 6

PMA (Permanent Magnet Alternator) in FMU (Fuel Management Unit) mounted to engine accessory case.

Question 7

What is the alternate power source for the FADEC?

Answer 7

Respective side DC Bus

Question 8

What criteria must be met for ATR to be armed?

Answer 8

• ATR selected on (avionics)
• Thrust levers in TOGA position

Question 9

What criteria must be met for ATR to automatically activate?

Answer 9

ATR Armed and one of the following:
- 20% Differential N1
- Loss of communication between FADECs

Question 10

How does ATR provide maximum thrust?

Answer 10

The FADEC commands the FCSOV (ECS) 1 and 2 valves closed with the effect that no bleed air will be extracted for the Environmental Control System.

Question 11

What is the position of the following valves after ATR is activated?
FCSOV (ECS) 1:
FCSOV (ECS) 2:
PRSOV - failed engine:
PRSOV - operative engine:

Answer 11

FCSOV (ECS) 1: CLOSED (Commanded by FADEC)
FCSOV (ECS) 2: CLOSED (Commanded by FADEC)
PRSOV - failed engine: CLOSED
PRSOV - operative engine: CLOSED (Open if Wing/Stab Anti-Ice valves are open)

Question 12

How many channels in each FADEC?

Answer 12

Two - 1 active and 1 standby

Question 13

What is the function of the active FADEC channel?

Answer 13

Actively controls all engine functions

Question 14

What is the function of the standby FADEC channel?

Answer 14

Monitors all engine functions and assumes control with failure of active channel.

Question 15

What determines the active FADEC channel?

Answer 15

The active channel alternates between engine cycles.

Question 16

When are both igniters commanded to operate? (3)

Answer 16

• Engine In-flight Start
• Auto Relight
• Ground Start with temp below 0 C

Question 17

When is only one igniter commanded to operate?

Answer 17

Ground start with temperature at or above 0 C

Question 18

What is the function of IGNITION switch OFF position?

Answer 18

Dry Motoring

Question 19

Where can we find approved oil types?

Answer 19

POH Vol 1 - Servicing and Maintenance

Question 20

What is the recommended time for checking oil quantity following shutdown?

Answer 20

Between 10 and 20 minutes