MQF ICT 2013

Question 1

Which of the following is the main advantage that Link 16 has over Link 11 and Link 11B?
A.Uses Ultra High Frequency (UHF) radios
B.It is the only secure data link available
C.Increased data rate
D.Air-to-Ground/Air-to-Air capability

Answer 1

Increased data rate

Question 2

The JRE Client is a remote user interface used to configure, route, and filter links on the JRE Server.
True or False

Answer 2

True

Question 3

What are the four MIDS LVT2 Radio Terminal Set Line Replaceable units?
A.R/T, Power Supply Assembly, Cooling Unit, and Mounting Base Assembly
B.Crypto, R/T, J11, and Chassis
C.voice, data, ECCM, and antenna
D.all of the above

Answer 3

R/T, Power Supply Assembly, Cooling Unit, and Mounting Base Assembly

Question 4

On the MIDS LVT2, the \_\_\_ must be powered on before the R/T can be turned on.
A.JRE
B.TACLANE MINI
C.Power Supply Assembly
D.SKL

Answer 4

Power Supply Assembly

Question 5

Where is the crypto fill port located on the MIDS LVT2?

Answer 5

J4

Question 6

You must ensure___ befire the SKL will successfully load crypto into any piece of equipment.
A.The SKL is powered on
B.A good connection is established between the SKL and equipment being loaded
C.The equipment being loaded is powered on
D.all of the above

Answer 6

all of the above

Question 7

____ is the normal operating capacity of the JTIDS/MIDS terminal.

Answer 7

High/54 kbps

Question 8

How many J Series messages types (categories/Sub-categories) are there?

Answer 8

32 categories/ 8 sub categories

Question 9

Which of the following is NOT a JTIDS Time Slot packing Structure?
A.standard double pulse
B.pack 2 double pulse
C.standard 8 single pulse
D.pack 4 single pulse

Answer 9

standard 8 single pulse

Question 10

Select the best answer below which accurately describes JREAP-B.
A.JREAP-B is a half duplex synchronous or asynchronous point-to-point connection
B.JREAP-B is a full duplex synchronous or asynchronous point-to-point connection
C.JREAP-A normally utilizes a RJ-45 connection to communicate via TCP/IP
D.JREAP-C normally utilizes a 1553 cable to connect to a STE for asynchronous communication

Answer 10

JREAP-B is a full duplex synchronous or asynchronous point-to-point connection

Question 11

The pseudo random hopping patter used during a transmission is based upon___.

Answer 11

Time, Crypto, and Net

Question 12

How many frequencies does JTIDS use?

Answer 12

51

Question 13

What JREAP protocol is commonly used for TCP/IP or UDP/IP operations?

Answer 13

JREAP-C

Question 14

What is the normal and extended range mode of Link 16?

Answer 14

300/500 NM

Question 15

Which mission planning document contains Annex K(task organization) and Annex K (communications.electronics) sections used for data link operations?

Answer 15

OPORD

Question 16

LInk 16 TDMA scheme provides ____ second frames divided into ____ time slots to be used for data transmissions.

Answer 16

12, 1536

Question 17

A total of two_____ messages must be received in order to achieve course sync.

Answer 17

Net Entry

Question 18

_____operates by communicating between two host JRE Gateways via a fixed communications connection using a token ring protocol. The serialized signal is packaged in a wave form allowing the signal to be sent through uplink satellite ratios to a satellite and down to a variety of receivers.

Answer 18

JREAP A

Question 19

Link 16 employs ____ messages.

Answer 19

J Series

Question 20

Wetsone operates in the ____ to support daily Link 16 training testing.

Answer 20

Gulf Common Network

Question 21

Looking for 146-150…

Answer 21

see front