Lecture 31 Flashcards
Length tension relationship:
At the level of the sarcomere the maximum active force (tension developed) is dependent on the degree of actin and myosin overlap`
At optimal length:
greatest tension produced due to maximum number of cross-bridges foremd
Decrease length:
reduces tension due to extensive overlap
No tension can form when:
Thick filaments meet Z lines are sarcomeres cannot shorten.
Reduced size of zone of overlap means:
fewer cross bridges formed and reduced tension
Zero zone of overlap results in:
zero tension due to no interactions between thick and thin filaments
Excitation-contraction coupling Part 1(the neuromuscular junction) step 1
-ACh is released into the neuromuscular junction, an AP travels down the motor neuron. Ca2+ enters the axon terminal. Vesicles containing ACh fuse with the terminal membrane, releasing ACh into the neuromuscular junction
Excitation-contraction coupling Part 1 step 2
Activation of ACh receptors:
- After step 1, ligand gated ion channels open.
- Opening of these channels allows movement of predominantly Na+ into the muscle cell making it less negative (end plate potential)
- The effects of ACh are short lasting as the enzyme ACh esterase rapidly breaks down ACh
Excitation-contraction coupling Part 1 step 3:
If sufficient ligand gated channels are opened the end plate potential reaches threshold.
- Voltage gated Na+ cahnnels open and an action potential is triggered
- The action potential is then propagated along the sarcolemma into the T tubule system
An action potential in skeletal muscle (5 steps)
- Small increase in Na+ permeability
- Na+ channels open. Na+ rushes in. Cell is depolarized.
- Na+ channels close. K+ channels open. Cell begins repolarization.
- K+ channels begin closing.
- Membrane potential stabilizes at resting level. Concentrations of Na+ and K+ are restored.
Excitation-contraction coupling Part 2 (calcium coupling) step 4
-Calcium is released from the SR. Ca2+ channels in the SR open. Ca2+ is then released into the cytosol
Excitation-contraction coupling Part 2 (calcium coupling) step 5
When Ca2+ concentrations reach a critical threshold the myosin binding sites on the actin filament are exposed allowing the cross-bridge cycle to occur.
Excitation-contraction coupling Part 2 (calcium coupling) step 6
-Contraction ends when Ca2+ levels fall
- Ca2+ is pumped back to SR via Ca2+-ATPase pumps
- Troponin moves back covering the myosin binding site
- The muscle twitch is complete
Creatine phosphate:
- For brief periods creatine phosphate can act as an ATP ‘store’
- Anaerobic
Anaerobic glycolysis:
fast but inefficient