Landing Gear Flashcards
Positioning the LANDING GEAR Lever _____ removes
hydraulic pressure from the Landing Gear System.
OFF
The Lever Lock Override Trigger in the LANDING GEAR lever bypasses the _____ under certain conditions.
the lever lock if the lever lock solenoid fails
A Main Gear Position Light is not illuminated with the
LANDING GEAR lever in the DOWN position. The
Supplemental Gear Position light is green. The respective
gear is
down and locked
The _____ supplies hydraulic fluid to raise the landing gear when Hydraulic System A engine-driven pump volume is lost due to an engine failure.
Landing Gear Transfer Valve
Opening the Manual Extension Access Door _____ Landing Gear _____.
disables / retraction
Pulling a Manual Gear Extension Handle _________ allowing the respective gear to free-fall.
releases the mechanical uplocks
With the Flaps greater than ________ pushing the Horn
Cutout switch will not silence the Landing Gear
Configuration Aural Warning (horn).
10
_____ supplies pressure to the Alternate Brake System if
Normal Brake System pressure is low or fails
Hydraulic System A automatically
Braking _____ if both Hydraulic Systems A and B are lost.
is available through a Brake Accumulator
\_\_\_\_\_ System(s) provide(s) skid"," locked wheel"," touchdown and hydroplane protection.
the Normal and Alternate Brake
Maximum braking automatically begins during a rejected
takeoff _____.
above 90 knots and retarding the forward thrust levers to IDLE
Landing with the Autobrake set to RTO:
results in no autobraking
The Autobrake select switch allows selection of
____________ .
increasing rates of deceleration
Autobrakes”,” when engaged”,” _____ when thrust
reversers and spoilers deploy during landing.
reduce pressure to maintain selected deceleration rate
Disarm the Autobrake System”,” after braking begins”,” by
_____ .
Correct Answer 4
1) applying manual brakes
2) moving the SPEED BRAKE lever to DOWN detent
3) advancing forward thrust lever(s) more than 3 seconds
after landing
4) all the above
