KR Performance Flashcards
What is the maximum weight for a normal thrust takeoff on XX runway?
ACARS Runway PMTOW or
MFPTW
From TLR what is the takeoff N1 Value?
Value listed next to planned temperature
Can the temperature on the TLR be higher than the highest temperature listed? Colder than listed?
No
If colder, use lowest temperature listed
If actual temperature is more than 10 degrees colder than planned temp, a new release is required
What is the limiting factor for takeoff weight?
Listed next to V1 speed, can include: A - max AFM charted weight B - brakes C - climb D - dry runway weight check (wet MRTW can’t exceed dry MRTW) F - field O - obstacle S - structural T - tires V - Vmcg
What is the flap setting?
Listed above max weights
Is the takeoff weight base on bleeds open or closed?
It is whatever it says at top of the section
What would the weight penalty be for going bleeds open?
Whatever value is under the temperatures when you find BL OP
What would your V1,VR,V2,VFTO speeds be for takeoff?
V1 most limiting factor (based on config)
VR,V2,VFTO is from speed cards
What type of procedure is this? 13 1000 FT DT H128 How would you fly this procedure
Standard engine failure procedure
Departing runway 13, fly straight out heading 128
Retract flats normal schedule 1,000’
Where do we find special procedures?
Below ACARS runways
How do you fly this procedure?
Follow instructions provided
Below ACARs runway section
above runway takeoff analysis
At what altitude is the turn to the sImple special SE departure procedure heading made?
Simple special departure will tell you
On a simple special SE departure procedure, IMC, non radar environment, to what altitude must the procedure be complied with?
3,000 ft AFE
After which you may proceed on course
On a simple special SE, VMC, non-radar, what altitude must the procedure be complied with?
1,000 ft AFE
After which you may proceed on course
How do you determine the max takeoff weight on a contaminate runway?
Calculate GTOW using Flightview
Find PMTOW in ACARS runway section
Find section of TO with the contaminate
Make sure OAT is less than MT