Jeppensen Chapter 7 Section D Flashcards

1
Q

In what Federal Aviation Administration publication may a switch derating factor table be found? __________

A

AC 43.13-IB

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

Switches must be installed in a __________ and __________ manner. This means that moving a switch __________ or __________ turns power on to the circuit.

A

logical,
consistent,
up,
forward

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

A SPST switch has __________ contacts and controls __________ circuit(s).

A

two,
one

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Normally a __________ has a fixed iron core.

A

relay

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

A __________ fuse has a fusible element that is held under tension by a small coil spring.

A

slow-blow

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

All aircraft circuit breakers must be of the __________-__________ type.

A

trip-free

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

The three basic configurations of circuit breakers used on aircraft are:
A. ____________________
B. ____________________
C. ____________________

A

A. Push-to-reset,
B. Push-pull,
C. Toggle type

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

Indicate the color of lens used for each navigation light position listed:
A. Left wing ____________________
B. Right wing ____________________
C. Tail ____________________

A

A. Red,
B. Green,
C. White

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

Anti-collision lights may be either of these two types:
A. ____________________
B. ____________________

A

A. Rotating beacon,
B. Flashing strobe

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

Always allow a strobe system to sit in the OFF position for at least __________ minutes prior to any maintenance operation.

A

five

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What does each of the three fingers represent in the right-hand rule for motors?
A. First finger ____________________
B. Second finger ____________________
C. Thumb ____________________

A

A. Direction of the magnetic field,
B. Direction of current flow,
C. Direction the wire moves

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

The stationary magnetic field in a DC electric motor may be produced by:
A. ____________________
B. ____________________

A

A. Permanent magnet,
B. Electromagnet

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Three types of field-armature circuit arrangements used in DC motors are:
A. ____________________
B. ____________________
C. ____________________

A

A. Series,
B. Shunt,
C. Compound

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

Series-connected DC motors have a __________ starting torque.

A

high

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

An aircraft starter uses a __________-wound DC motor.

A

series

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

The three types of AC motors are the:
A. ____________________ motor.
B. ____________________ motor.
C. ____________________ motor.

A

A. Universal,
B. Induction,
C. Synchronous

17
Q

The speed of an AC induction motor is determined by:
A. ____________________
B. ____________________

A

A. The design,
B. The applied AC frequency