Day 3 Progress Check Flashcards
Question 11/1
What should be done if the electrical load exceeds the generator’s or alternator’s capacity?
Decrease the load to within the rated capacity
Question 21/1
How should wires be protected when routed near high-temperature areas?
Install asbestos or fiberglass jackets
How should environmental protection be ensured for connectors in aircraft wiring?
Selection of connectors based on fluid, vibration, and thermal resistance
Why is it important to know all actual current draws when determining electrical load requirements?
To ensure proper operation and avoid overloading
What should be done to protect disconnected wires in an aircraft?
Use a bag or plug to cover and protect them
Question 61/1
What is the purpose of a junction box in an aircraft wiring system?
To protect terminal strips from damage and shorts
Why should wires be routed parallel or at right angles to aircraft stringers and ribs?
To avoid diagonal runs that can cause structural damage
What is the recommended clearance between wires and aircraft structure for bare metal?
3/8 inch
What is the primary concern when installing electronic equipment in an aircraft’s electrical system?
Capacity to carry the load and prevent overheating
Which type of connector is typically used in areas that are frequently disconnected?
Quick disconnect connectors
What is the primary function of lacing and tying wire bundles?
To facilitate installation, maintenance, and inspection
Which of the following is considered a continuous load?
Navigation lights
What must be done to ensure the secure installation of terminal studs in a terminal strip?
Ensure proper separation and prevent rotation
What is the minimum bend radius for a wire group or bundle?
10 times the diameter of the largest wire
Why is it important to use clamps and grommets in wire routing?
To prevent chafing and abrasions
