ICF Flashcards
Name three types of ICF
Block plank and panel form
What is the standard Block size?
419 mm (16 1/2) high and 286 mm (11 1/4 )wide and 129 mm 48 long so (16 x 48)
ICF forming starts at the
Corners and work towards the centre
And describe the bracing needed in the corners of the blocks
Nail two 2x6’s into an L stand it in the corner and plum and brace it
How are the Blocks braced along the rest of the wall?
Using vertical two by fours that are fastened to the furring strips on the blocks with screws and braces are attached to these uprights
Where do you have to make special bucks for?
Door and window openings
How are scaffold planks attached to the system?
They are attached to the vertical braces or bearers
What is the minimum thickness of an ICF foundation?
150 mm 9.15.4.5
When is ICF foundation considered to be laterally supported
Top and bottom 9.15.4.3.4
When is an ICF foundation considered to be laterally supported at the top
When such wall supports a solid masonry, superstructure floor joists are embedded in the top of the foundation when the floor system is anchored to the top of the foundation with an a Anchor, bolt
When is an ICF foundation considered to be laterally supported at the bottom
Supports backfill, not more than 1.2 mm in height, supported at footing by a sheer key and at the top by ground floor framing
Horizontal reinforcement shall consist of 110 M bar and related not more than 300 mm from the top of the wall
True
If the height of the finished ground above the finished basement floor is 1.6 m in the maximum unsupported basement wall is 2.44 m what size bar and what size spacing would be called for
10 AM, bar at 400mm O.C
Where should reinforcement be located when placed in a foundation wall, both vertical and horizontal and what would be the minimum cover?
Inside half the wall section and with a minimum cover at 30 mm from the inside face of the concrete 9.15.4.51B and 2B
How would a cold joint be reinforced?
 No less than 115 mm bar at not more than 600 mm on centre and embedded 300 mm on both sides of this joint