Homework 3 Flashcards
Before starting an inspection what must you do? Choose all that apply.
Remove panels, fairings, doors and cowlings
Clean the aircraft
Quality logbooks can do what?
Increase the value of the aircraft
What manual would you use for work normally performed with the unit off of the aircraft?
Overhaul manual
Why must you have a knowledge of the CFR’s?
All work done on aircraft must comply with CFR provisions
What may be included on an AD? Choose all that apply.
Compliance time period
Necessary corrective action
Description of the difficulty experienced
What is issued for alterations to an aircraft that are not specified on the original TCDS?
STC
When is a 100-hr inspection required on an aircraft operated under FAR part 91?
It’s used for commercial purposes
Where can procedures to be followed for progressive inspections be found?
FAR part 91 Section 91.409(d)
According to FAR 43 appendix D what must you inspect the propeller bolts for?
Improper torque and lack of safetying
Under CFR 43 Appendix E, under what condition must altimeter static systems be tested within 24 months?
When operated under IFR conditions in controlled airspace
When might a special inspection be required?
When something out of the ordinary happens that can affect airworthiness
When might a overweight landing inspection be required?
When the airplane lands at a weight above its maximum design landing weight
More serious damage to these components may occur after a lightning strike
Non-metallic structures
Why do air filters tend to become obstructed more quickly on aerial application aircraft?
Because they continuously operate at low altitudes
