Fire Protection Flashcards
There is no difference between APU fire detection/extinguishing whether in flight or on the ground with either engine running. [8.80.10]
True or False?
True.
A “BOTTLE DISCH APU” displayed on EICAS indicates: [8.80.30, 8.80.10]
The APU fire extinguisher bottle is low.
What is indicated by the BOTTLE 1 DISCH ENG EICAS message during preflight? [8.80.10]
Fire bottle 1 has discharged or pressure is low.
Which of the following will unlock the engine fire switch? [8.80.20]
A. Pushing the lock override button beneath the fire switch.
B. A fire signal from the respective engine.
C. Placing the fuel cutoff switch to the cutoff position.
D. Any of the above.
On the ground, after the FWD CARGO FIRE ARM switch is selected to ARM, all
seven bottles discharge immediately. [8.80.10]
True or False?
False.
Which of the following statements is TRUE concerning a wheel well fire? [8.80.10]
- There is NO built-in fire extinguishing system for the wheel well.
- The main wheel well has both fire and overheat detection.
There is no flight deck indication of lavatory smoke. [8.80.10]
True or False?
False.
When the engine fire switch is pulled up, rotating the switch in either direction discharges one extinguisher bottle into the associated engine, and then 30 seconds later discharges the remaining bottle into the same engine. [8.80.10]
True or False?
False.
When in flight, and a fire is sensed, the CARGO FIRE protection system automatically discharges two bottles immediately. If the airplane is on the ground within 15 minutes, what happens at touchdown? [8.80.10]
One metered bottle will automatically discharge at a reduced rate.
When the airplane is on the ground with both engines shut down, a fire signal from either APU fire loop will cause: [8.80.10]
The APU to automatically shut down immediately and the fire bottle to discharge after a 15 second delay.
In regard to the hydraulic system, pulling an engine fire handle: [8.80.20]
- Will shut off fluid to the associated pump.
- Depressurizes the engine driven pump.
Failure of a single channel of an engine fire detection assembly will only be indicated by a status message and may have no accompanying EICAS caution or warning message. [8.80.10]
True or False?
True.
Selecting ARM on the FWD cargo fire arm switch will: [8.80.20]
A. Configure the FWD equipment cooling system to OVERRIDE mode.
B. Shut down the forward cargo heat.
C. Command the air conditioning packs to provide minimum flow rate consistent with pressurization demands.
D. All the above.
Which of the following are indication(s) of an engine fire? [8.80.10]
- The fire bell sounds.
- The engine FUEL CONTROL (L or R) switch fire warning light illuminates.
Which of the following are indications of a cargo compartment fire. [8.80.10]
A. The master WARNING lights illuminate and the fire bell sounds.
B. The “FIRE CARGO (FWD/AFT)” EICAS message illuminates.
C. The FIRE CARGO (FWD/AFT) fire warning light on the overhead panel illuminates.
D. All the above.