Eagle 2

Question 1

Eagle 2 What is it?

Answer 1

Monitors one to six gases simultaneously. Standard configuration includes 4 sensors for- Combustible gas(LEL,PPM,VOL),Oxygen, Carbon monoxide, Hydrogen sulfide (H2S)

Question 2

operating modes

Answer 2

Normal mode- Typical for confined spacer or area monitoring.
Bar hole mode- checking for underground gas leaks
Leak check mode- Locates leaks in piping

Question 3

Meter alarms

Answer 3

CH4(MEthane) O2 H2S CO

10-50% 19.5-23.5% 5-30PPM 10-35PPM

Question 4

LEL sensor

Answer 4

Catalytic combustible gas sensor uses a catalytic element for detection

Question 5

Oxygen sensor

Answer 5

Galvanic type of sensor, gas diffuses into sensor, oxygen reacts and produces a current

Question 6

CO and H2S sensors

Answer 6

Electrochemical sensors that allows gas to permeate membrane and diffuse into the electrolyte. gas reacts and produces a current

Question 7

Obscure stuff

Answer 7

Diaphragm pump can draw sample up to 125ft

Question 8

Charcoal filter

Answer 8

contains activated charcoal. CO sensor will respond if exposed to H2S and certain hydrocarbon gases. Charcoal filter scrubs these gases out

Question 9

3 operational modes in normal mode

Answer 9

Measuring, display and calibration

Question 10

What happens when failed sensor

Answer 10

Gas reading for failed sensor will be replaced by XXX

Question 11

Obscure stuff

Answer 11

Before using Eagle 2 set fresh air readings. Hold down air button to perform a demand zero

Question 12

Obscure stuff

Answer 12

Wait 10-15 seconds to observe display for gas readings

Question 13

Obscure stuff

Answer 13

Catalytic gas sensor will respond to any combustible gas. it will shut off when exposed to high levels of combustible gas 100%UEL

Question 14

button stuff

Answer 14

To switch between %LEL,PPM and %VOL use range (down) shift button.

Question 15

LEL for methane

Answer 15

5% vol or 50,000 PPM

Question 16

how long does it take for resopnse time per foot of hose

Answer 16

12-15 seconds

Question 17

Catalytic combustible sensor

Answer 17

is slightly affected by humidity

Question 18

Obscure stuff

Answer 18

False alarms may be triggered by radio frequency

Question 19

What happens when something is wrong with the unit itself

Answer 19

It will alarm double pulse tone once per second

Question 20

Low batt warning

Answer 20

Eagle 2 is still fully functional but only has 1-2 hours operating time

Question 21

trouble shooting

Answer 21

Auto calibration fails-check for leaks make sure its properly set up for calibration, change charcoal filter

Question 22

trouble shooting

Answer 22

display says system fail- Press and hold range (down) shift, then press display adjust no. enter password 1994 go to set default screen. press air(up)yes button twice