Drogue Flashcards
What does the deployment yoke connect?
The drogue gun slug to the apex of the extraction chute.
Which component attaches the drogue parachute to the ejection seat?
Drogue riser assembly.
What type fabric is used to make the extraction container cover.
Aluminized nomex.
How often do you inspect the ACES II drogue chute?
Every 3 years or as necessary. Accept on the B1-B then every 5 years.
What do you inspect on the hasp rod and retaining latch?
Proper mating.
What is the service life of the ACES II drogue assembly?
13 years from DOM.
How many tacking do you use to attach the right riser leg to the seat?
4
Where do you position the apex of the drogue canopy in its compartment?
Halfway between the top and bottom of the drogue compartment.
What is the first item you stow in the extraction container?
The high drag bridle.
What component do you tack to the C lanyard.
The deployment yoke loop.
What size thread do you use to perform small darns on the drogue canopy?
Size A nylon.
What do you use to measure and mark the line and how much tension is used if a line is replaced?
Measure and mark 1500 pounds braided nylon using 30 lbs of tension.
What is the maximum size damage that may be repaired on the high drag bridal line?
1/2 in length or diameter.
What must be done if you discover a radial ribbon that has a 1/2 in hole, cut or tear?
Replace the drogue canopy because it exceeds the 3/8 in max allowable.
How much must the new tape extend beyond each side of the damaged area if you are repairing a vertical ribbon on the ACES II drogue parachute?
At least 4 in beyond each side of the damaged area.
