Com/Nav Oral Flashcards
Is a certificated airframe mechanic allowed to adjust a communications transmitter?
No, a license issued by the Federal Communications Commission is required.
Which frequency band is used for most aircraft communications?
The VHF band, between 30 and 300 megahertz.
In which frequency band does the VOR equipment operate?
In the VHF band, between 108.0 and 117.95megahertz.
What is the preferred location for a VOR antenna on an airplane?
On top of the aircraft, along the center line of the fuselage.
Which component of the Instrument Landing System (ILS) shares the antenna with the VOR?
The ILS localizer.
In what frequency band does the DME equipment operate?
In the UHF band, between 962 and 1,024 megahertz and between 1,151 and 1,213 megahertz.
What is the preferred location for a DME antenna?
Along the center line of the belly of the aircraft as far from any other antenna as is practical.
On what frequency is the marker beacon signal transmitted?
75-megahertz.
What do the three marker beacon lights indicate to the pilot?
The blue light indicates passage over the outer marker in an ILS approach, the amber light indicates passage over the middle marker, and the white light indicates passage over any other location specified on the instrument approach.
What precautions should be observed when working around aircraft radar?
Aircraft radar should never be operated when there are people or buildings within 100 yards of antenna sweep or when aircraft is being fueled or defueled due to the strength og electrical energy from the pulses of the radar antenna being able to seriously injure any person struck by them.
Which frequency band is used for long range communications from an aircraft?
The high frequency band (2 to 25 megahertz).
What is meant by a transceiver?
A piece of radio communications equipment in which all of the circuits for the receiver and the transmitter are contained in one housing.
On what two frequencies does the Emergency Locator Transmitter operate?
121.5 and 243.0 megahertz.
Where is the ELT transmitter normally located on an aircraft?
In the tail of the aircraft or as far aft as possible, so it will be least likely to be damaged in a crash.
What three components of an Instrument Landing System are installed in an aircraft?
The receivers for the localizer, the glide slope, and the marker beacons.
