Cockpit Prep Flashcards

1
Q

Setup for CVR Test

A

RCDR GND CTL and Parking Brake must be ON to perform CVR test

LOUDSPEAKER VOLUME knob - OFF (BOTH SIDES)

ACP INT/RAD sw (CAPT and F/O) - SET to INT

INTERPHONE VOL (CAPT and F/O) - RELEASE (volume to minimum)

CVR TEST pb - PRESS AND MAINTAIN

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

When is a complete ADIRS alignment required?

A

First flight of the day

Crew change

GPS is not available and NAVAID coverage is poor on the expected route

GPS is not available and expected flight time exceeds 3 hours

International and Alaska flights

Class 2 airspace

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

What is required if IR positions disagree by greater than 5NM?

A

IR Fast alignment

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

When can you select the ADIRs to off?

A

Five minutes after block in when the FMGC and AOC have entered the preflight phase.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What are you checking on the FIRE TEST?

A

FIRE pushbuttons - CHECK IN and GUARDED

AGENT lights - CHECK OUT

Press each TEST pushbutton in turn and check:

– FIRE pushbutton light on

– SQUIB and DISCH lights on

– MASTER WARN lights on

– CRC

– FIRE warning on ECAM

– FIRE light on ENG panel

– Push MASTER WARN to verify MASTER WARN lights and CRC cancel

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

How do you check the battery voltage and what are you looking for?

A

BAT switches OFF

25.5 volts minimum (ensures charge above 50%)

(If ELEC system is supplied with AC power, BAT VOLTAGE check is not required)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

SAFETY EXTERIOR INSPECTION

upon arriving at the aircraft

A

WHEEL CHOCKS - CHECK IN PLACE

LANDING GEAR DOORS - CHECK POSITION

APU AREA - CHECK

CONTAMINATION CHECK - PERFORM (as appropriate)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

PRELIMINARY COCKPIT PREPARATION

PRIOR TO APPLICATION OF ELECTRICAL POWER

A

LOGBOOK - CHECKED

AIRCRAFT OUT OF SERVICE PLACARD - NOT INSTALLED

OEBs - CHECK

CAT Status Indicator - CHECK

RNAV RNP .3 AR CAPABLE Placard - CHECK

REAR and OVERHEAD CIRCUIT BREAKER panels - CHECK

REQUIRED MANUALS - CHECK

EMERGENCY EQUIPMENT - CHECK

GEAR PINS AND COVERS - CHECK

WEATHER RADAR - OFF

ENG MODE selector. - NORM

ENG MASTER 1 and 2 - OFF

LANDING GEAR LEVER - CHECK DOWN

WIPER SELECTORS - OFF

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

REQUIRED MANUALS

A

QRH (2)

(NOTE: Each aircraft is supplied with two aircraft specific QRHs. The aircraft may operate with a single QRH onboard provided Dispatch is notified. Dispatch may place a note on the release to alert subsequent crews of a missing QRH. In this case, no additional notification to Dispatch is necessary. The missing QRH will be replaced by the Technical Publications Department within three days of notification.)

MEL/CDL

Diversion/Forms Kit

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

EMERGENCY EQUIPMENT

A

Life vests stowed (4)

Crash axe stowed (1)

Protective Breathing Equipment (PBE) stowed and serviceable (1) - Check that humidity indicator is “Blue” and “Green” Tamper Evident Seal is installed.

Portable halon fire extinguisher lockwired and pressure in the green area (1)

Full face (smoke goggles) oxygen masks stowed (4)

Flashlights stowed (2)

Escape ropes stowed (2)

Protective gloves (1 pair)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly