Chapter 5 - chimneys and vents Flashcards
Chimney entrance. Connectors shall connect to a masonry chimney flue at a point not less than ______ above the lowest portion of the interior of the chimney flue.
12”
Masonry chimney flues shall be provided with a cleanout opening having a minimum height of:
6 inches
The upper edge of the opening shall be located not less than _____ below the lowest chimney inlet opening.
6 inches
Venting system shall not extend into or pass through any
Fabricated, air duct or furnace Plenum
Chimneys shall extend _____ above the highest connected appliance, draft hood, or flue collar
5 feet
The locations of gas vents shall comply with table?
503.6.5
Single wall metal pipe shall be constructed of galvanized sheet steel, not less than
0.0304 inches thick
Single wall metal pipe shall not originate in any unoccupied attic or concealed space and shall not pass through
Any attic, inside wall, concealed space or floor
Where the vent connector used for an appliance having a draft hood or a category, one appliances located in or passes through attics, crawlspaces, or other unconditioned spaces that portion of the vent connector shall be listed as
Type B or type L
A vent connector shall be installed without drips or sags and shall slope upward toward the vent or chimney, not less than
1/4 inch per foot
The maximum horizontal length of a single wall connector shall be ____ of the height of the chimney or vent
75%
The maximum horizontal length of a type B double wall connector shall be ______ the height of the chimney or vent
100%
How far above the bottom of the wall furnace, in vertical feet, must a Type B-W gas vent terminate?
12 feet
503.6.6 Minimum height
Where steel shield plates are required to protect vents in a concealed location from physical damage, what is the minimum required thickness?
No. 16 gauge
How many feet must single-wall metal pipe terminate vertically above the highest draft hood outlet for an appliance?
5 feet
503.7.3 Termination