CAPA Flashcards
Capa Knowledge
What are the 8 uses of the CAPA
General Pumping Appliance
Rescue
Water and Foam Delivery Tower
Observation Tower
Equipment and personnel lifting
Water Supply
Bridging
Limited cage operations below ground level
lighting tower
mass decontamination shower
What are the CAPA specifications?
Height
Length
Weight
Max Work Height
Max Elevation Angle
Max Side out reach
Max side reach full height
max down reach cage floor below ground
Max load lifting eye (main ladder)
Max cage load
max rescue stretcher platform load
max wind speed
3.95m
10.05m
26t
32M
75*
22M (1 person) 25m no cage
9.5M
-4m
4000KG
500kg
250 or 300kg depending on config)
45kmph
Visualise the;
Articulated ladder
Main Ladder
Turret operator position
Turn table
Rear jacking panel
outriggers
working deck
ladder sections
rescue cage
cabin
Where are the CAN-Bus isolation/ reset switched?
Near side front locker
Visualise the jacking control panel inclusive of;
Display screen
Emergency Stop
Cage deployment/ stow
Outriggers Indiv controllers
4 way control lever
What does the green boat symbolise
Pressure release symbol
what does the pressure release symbol represent (greenboat) when jacking
ground pressure has been achieved on all jacks and hydraulic control has been transferred to the turn table.
Why do the ground plates need to be used in the criss cross manner
if the ladder strikes a power line then the plant will be earthed
What is the only situation where you would jack both the CAPA front wheels off the ground?
obtain max down reach when working directly off the back of the appliance
what are the max angles of the JACKS and TURN TABLE
Jacks 14 Turn table 7
whats the full red ring mean when jacking?
axle locks have been disengagedq
what important info can be obtained from the cab regarding siting the appliance
side to side inclination angle
front to back inclination angle
either via the bubble or the cabin display screen
Rosenbauer NH55 Pump Ratings
Main Pump (all heigths)
High pressure pump
water tank capacity
Foam Capacity
4500 LPM @ 1000kpa
400 LPM @ 4000kpa
1200 L
200 L Class A
Why is it important to ensure all components of the cage are housed correctly prior to making up the cage ladder?
To prevent damage to the cage
to enable to cage to be retracted
to enable the cage to be housed
HYD pressue tp the jacks and aerial ssection can be lost if the PTO fails T or F
T
what is the procdure for error message and it is safe to move the ladder/ cage without damaging it?
Press and hold override impact button
Press the deadman switch
release the override impact protection button
Execute the desired movement
list the 4 ways to control the monitor on the cage
Remote housed in pump panel
monitor controls in cage
manual mode from cage
monitor controls in turret