Anti-Ice Flashcards

1
Q

During NAC HT ground checks what does a momentary Amber NAC HT indicate?

A

This is a Disagreement light.
Either 6psi+valve open
Or
Pressure bleeds off+ valve closed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What are the NAC HT Limits on the ground?

A

Without engine running: 5 seconds
Engine on: >15°C=30 seconds

Do not use >65%N1 except for take off

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

In the event of an electrical failure what will happen to NAC HT

A

NAC HT and Stator heat fail ON

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Windshield Heat comes from where?

A

LP manifold Bleed air

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

How long does WS HT take to fully open?

A

Takes 15 seconds for valve to fully open and fully close

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Explain WS HT Over heat conditions.

What are the high and low limits on the ground and in the air?

A

There are low limit (250°F ground) and high limit (347°F airborne) thermoswitches installed.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

WING HT comes from where?

A

LP manifold (HP as back up)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What are the underheat/overheat conditions that would bring on the WING HT annunciation with STAB HT switch on

A

<58°F Underheat

>215°F Overheat

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What is the function of the HP solenoid in regard to STAB HT?

A

With temp sensors below 600°F, electrical power is applied which opens the HP solenoid allowing HP air to help maintain wing heat in normal range during reduced engine rpm operations.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

During ground ops of the STAB HT (Batt charging bus) on the ground (squat switch) what is the solid light indicate as opposed to flashing?

A

If solid light on the ground this indicates good self test and normal ops

If flashing on the ground this indicates a failure of the self test.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

STAB HT steady light on in the air, what does this indicate?

What if its flashing in the air?

A

Either a failure or malfunction, check amps for indication

If flashing this means the Parting Element is gone.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

With WSHLD DEFOG in operation what is an under temp and what is an over temp?

A

<85°F equals an under temp

> 150°F equals an over temp

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What temp does WSHLD DEFOG in normal keep? What about in low?

A

110°F in normal

95°F in low

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

WSLD DEFOG power comes from where?

A

Electrical power is supplied by two L WSHLD circuit breakers (one DC and one AC) on the pilot side

Also two R WSHLD circuit breakers (one DC and one AC) on the copilot side

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Windshield alcohol is available to the pilot side only, how many Gallons and how long is ops available? When would you get a ALC LOW caution light?

A

2.35Gallons
45min of ops Captain side only
ALC LOW= 10% low triggered float switch

How well did you know this?
1
Not at all
2
3
4
5
Perfectly