AERONAUTICAL ENGINEERING MAINTENANCE MANAGEMENT MANUAL 13020.1H Flashcards
Three basic elements comprise the aeronautical maintenance system, what are they
A management element, a technical element, and a production element.
Management element is overseen by whom?
CG-41
Technical element is overseen by whom?
ALC
Production element Is overseen by whom?
Operating activities
Depot level maintenance is accomplished by who?
ALC designated by CG-41
Standardized maintenance improves what?
Overall maintenance quality, capability, and reliability
What manual provides guidance, policy, and procedures about Personnel Resources?
COMDTINST M5312.13 (series).
An Availability Index (AI) indicates what?
The percentage of time that aircraft assigned to Air Stations are available to perform Coast Guard missions
AI= [100-NMCT] where NMCT=Not Mission Capable Total is calculated based off what?
NMCS + NMCD + NMCM
NMCT Target?
The USCG target for aircraft availability is 71% (which equates to an NMCT of 29%).
NMCS Target?
A target of 5% is a planning goal for NMCS rates (this equates to a parts availability rate of 95%)
Who is responsible for financial management of maintenance?
Engineering Officer (EO).
What manual provides a more detailed depiction of various CG funds?
Financial Resource Management Manual (FRMM), COMDTINST M7100.3
Aviation units receive funds under what?
AFC 30 funds
Who has final authority for sub-allocating funds?
CO
Who will review and recommend changes to standard aircraft configuration?
ACCB
What outlines the specific weight and balance requirements for USAF aircraft?
AFTO-1B-50
Functional checks are divided into what?
Ground checks, flight verification checks, and test flights
Who may waive a test flight for flight control maintenance?
CO
In the EAL paper copy logbook, the PICs signature goes where after a pre-flight brief?
In the Quality Assurance Briefing block.
The signature on the briefing block for Flight Safety Maintenance Document, certifies what?
A pre-flight briefing was given by QA or maintenance release authority
Who has custody of aircraft during pick-up and delivery for PDM?
PIC’s home unit (ALC or the operational unit) assumes custody and ownership during the transfer flight to or from ALC
Who has responsibility of the ACCB process guide?
The Chief, Office of Aeronautical Engineering (CG-41), and the Commanding Officer of the Aviation Logistics Center (ALC) have the central responsibility for maintaining the Aircraft Configuration.
The following units are designated Prime Units for the indicated aircraft and aviation life support equipment. What are each aircrafts Prime units?
ALSE - ATC Mobile SE - ALC HC-27 - APO Elizabeth City HC-130J - Elizabeth City HC-130H - Clearwater HC-144 - ATC Mobile MH-60 - Elizabeth City MH-65 - Atlantic City C-37 - Washington
All Flight Manual changes are submitted via what form?
AF Form 847
All unit avionics shops are required to maintain an in-house capability for avionics repair at what level?
Class C-level.
Precedence of manuals to use in maintenance?
ACMS, Coast Guard, Air Force, Navy, Army, Commercial (ACAFNAC).
When conflict of information exists what takes precedence over CGTO’s?
ACMS MPCs shall take precedence over CGTOs.
Who is the final release authority for all class A and B mishaps?
CG-113
Volcanic ash is typically composed of what?
Extremely fine particles of glass shard and pumice
Completed MPCs will be retained for how long?
90 days
Maintenance errors contribute to approximately how much of commercial and aviation mishaps?
20%
Broad guidance for electronic test equipment calibration is contained in what?
Chapter 27 of the Electronics Manual, COMDTINST M10550.25 (series)
Chapter 27 of the Electronics Manual, COMDTINST M10550.25 (series)
Both AFC-30 and AFC-41
Responsibility for the recovery and salvage of aircraft?
CO
Who designates a QA?
EO
How often shall salvage plans be updated?
Annually
What vessel is considered adequate recover MH-60’s?
Polar class icebreakers
A written report of all encountered salvage and recovery challenges should be submitted to Commandant (CG-41) via the chain of command within how many days?
30 days of occurrence
H-65 main hoisting/gunwale?
30,000 pounds (Main Hoisting Capability)
25 ft (Ability to Hoist Outboard of Gunwale)
H-60 main hoisting/gunwale?
50,000 pounds (Main Hoisting Capability)
50 ft (Ability to Hoist Outboard of Gunwale)
Calibration will be in accordance with what part of the 110?
CGTO PG 85-00-110 and Chapter 8
