11-217 v3

Question 1

Designated ground check point

1) Degree tolerances
2) Distance Tolerances

Answer 1

1) 4 DEGREES OF CHECKPOINT

2) 1/2 MILE OR 3% of distance whichever is higher

Question 2

Tacan sends morse code message how often?

Answer 2

once every 30 seconds.

Question 3

1) ILS cat 1 has what HAT and vis requirements?
2) ILS cat 2 has what HAT and vis requirements?
3) ILS cat 3c has what HAT and vis requirements?

Answer 3

1) 200 and 1/2 mile
2) 100 and RVR 1200 feet
3) 0/0 with no HAT or Vis requirement

Question 4

Outer Marker is located how far from runway threshold?
Middle Marker is how far from threshold?
Inner marker is associated with what type of ILS ?

Answer 4

1) 5 NM from threshold
2) 1/2 mile from threshold
3) associated with Cat 2 and higher ILS located at DH

Question 5

1) Localizer can be how far off of center line?

Answer 5

1) up to 3 degrees.

Question 6

Back course ILS CDI should be where unless BC detector is associated with system?

Answer 6

1) Arrow should be on bottom of course

Question 7

Touchdown adn rotation points when following a larger aircraft.

1) you want to touch down infront or behind the larger aircraft’s touchdown point?
2) you want to take off before or after the larger aircrafts takeoff point.

Answer 7

1) Touchdown after larger aircraft on landing

2) Takeoff before larger aircraft

Question 8

What does ATC have to report when a heavy aircraft takes off or lands?

How long do you wait?

Answer 8

That there is a heavy aircraft that did either action

2) 2 minutes

Question 9

What is the formula for calculating true airspeed

Answer 9

IAS + (2% * altitude)

300 KIAS + (2% x 20,000 feet)

300 + (2% x 20,000 = 400)

= 700 TAS

Question 10

What is the VDP formula

Answer 10

VDP = HAT / 300 (For 3 degree glide slope)

Question 11

What is the formula for VVI

Answer 11

(nm / min) x (pitch change) x 100 ft /nm

5 nm/min x 3 degrees x 100 ft/nm
= 1500 ft/nm

Question 12

What is the formula for turn radius?

Answer 12

TR = (TAS / 60) - 2
TR = (240/60) - 2
TR = 4 - 2
TR = 2 nm

Question 13

how far do you need to perform a 45/180 maneuver?

Answer 13

5 nm at 180 knots

Question 14

What are the techniques for displacement for circling?

Answer 14

1) 15 seconds perpendicular
2) 30 degrees off for 45 seconds
3) 45 degrees off for 30 seconds

Question 15

What is RVSM ranges

Answer 15

FL 290 - FL 410

Question 16

RVSM reduce the standard range to what?

Answer 16

It goes from 2,000 down to 1,000 due to increased instrumentation.