102c: Stationary Power Tools Flashcards
Use fence and crosscut guide together on table saw?
NEVER
What size blade can a 10-inch table saw take?
10-inch
When should you safely use a push stick?
When distance between blade and fence is less than 4”
Why do table saws have fingers and splitters?
Keep the material from pinching closed and kicking back off the blade
What two basic things need to be checked on a table saw?
Blade square to table
Fence parallel to blade
What can band saws do that table saws can’t
Respawning material and curved cuts
What is required before thickness planing?
One flat face and one square edge
What happens when a jointer out feed table is too low?
Blade clips the board at the end causing “snipe”
What occurs when a jointer out feed table is set too high?
The board glides at an upward angle and causes a taper
Why can I use to make evenly lined up holes on a drill press?
Slide material along a fence between drilling
Can I sand on a drill press?
Not ideal but can use drum attachment
Which direction should I come at a belt sander from?
Against the belt elation so the material doesn’t fly away
