Utility Systems Flashcards
The Flexible shaft is connected by a small coupling at the __________?
The Flexible Shaft is connected by a small coupling at the motor and the converter.
How often should the Pivot Stud be lubricated?
The Pivot Stud should be lubricated every 30 days.
What are the four positions of the Multi-Position switch?
The Multi-Position switch is a four position switch, labeled OFF, LOW, HIGH, and PARK.
Each windshield has its own ________?
Each windshield has its own controller.
Where do the electrical terminals in the windshield receive its power from?
The windshield has electrical terminals for the power input from the controller and two parallel wired temperature sensors
What function does the Over Temperature Sensor provide?
The sensor prevents cabin over heat as a result of a Mixer failure.
What does the heating and ventilation system utilize to provide heated air?
The heater and ventilation system provides bleed-air heat and forced air utilizing a heater mixing unit and AC vent blower.
What components make up the cargo hook system?
The cargo hook system consists of a 9000 pound-capacity hook and electrical circuits which control it.
How is the cargo hook pendant marked?
The cargo hook pendant is marked NORMAL RLSE and EMER RLSE.
What is used to discharge the hook in an EMERGENCY?
The Explosive Cartridge (Squib) is located in the cargo hook; this squib is used to release under emergency conditions.
Where are the electrically heated pitot static tubes located?
The electrically heated pitot static tubes are located on the cockpit roof, aft of the pilot and copilot door.
Where are the pitot static heaters located?
Each pitot tube has two heating elements, one in the mast and one in the tube.
How high can the temperature be to check the windshield anti ice?
27 deg C
